0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you remove the starter from 1991 cutlass supreme?
transmission
Replace the ecm on 91 cutlass ciera?
The ECM is located behind the glovebox on a 1991 Cutlass Ciera. Pull the glove box out to see it. Once located remove the mounting hardware and unplug it from the car. Replace the unit.
How do you repair the starter drive on a 1991 4x4 5.7L GMC 12 ton truck?
Replace Remove starter Remove solenoid at top of starter Remove front end of starter for access Remove locking washer from starter shaft Drive should slide off shaft
How do you replace starter on 2.3cy 1991 Pontiac grand am?
How do you replace starter on2.3 cy 1991 pontiac grand am
Where is the starter on a 1991 Olds Cutlass Cierra?
Follow the pos battery cable and it is at the engine end.
How do you replace a starter on a 1991 pathfinder?
I have a 1990 pathfinder and just changed the starter 3 days ago. It was pretty simple but i had to remove the oil filter to get it out and it was still hard to get out.
How do you change a starter gear in a 1991 buick lesabre?
replace starter
How do you remove a starter on a 1991 Nissan Pathfiner?
must remove oil filter to get starter out have fun
What is the cost to replace a ball joint on a 1991 cutlass supreme?
price on replaceing ball joint 1993 cutlass supreme
How do you replace a flexplate on a 1991 Chevrolet caprice?
Remove the transmission and starter. Unbolt the flexplate from the crank. While you're at it, replace the rear main seal. Replace the flexplate and torque bolts to manufacturer's specs.
How do you remove the starter on a 1991 Chevy S-10?
Disconnect the - battery cable Raise and support vehicle Disconnect the wiring harness at the top of starter Remove starter mounting bolts Remove starter
How do you replace a starter on a 1991 Chevrolet Lumina with a V6?
Remove the negative battery cable then the cables off of the starter then the bolts holding it on and work it out.new answerOn the 3.1 engine, you will definitely have to remove the oil filter and possibly the crank position sensor.
