If it is similar to a 2000 Avalon panel, there were a total of of 7 screws and two door panel clips. One screw is in the handle itself (is that what you are fixing?), behind a square plastic tab. A large sgrew is revealed by prying up the armrest cover. Two screws are hidden under round tabs. All of the prying is done easily but by carfeully using a taped flat bladed screwdriver.
It took me about twenty minutes, after I read an online description on changing a Camry door handle for the same model year. My handle also broke. The procedures were same but the cost at my Toyota for the Avalon parts were much higher than the stated Camry parts. I live in Hawaii.
You need to remove the screws and then take a pry bar and stick it under the panel. Lift the bar until you hear some pops and continue all the way around the door panel. You might brake some pins off, that's what I'm trying to find now. Hope you can get it.
This is answered on page 5. Searching the web for Camrys will have many hits and pictures. My 2000 avlon panel came off with the help of a 2000 Camry post.
Remove the cover on the interior by prying then remove the three bolts with a 10 mm ratchet and pull it out.
First remove your door panel and interior lock module modular with T30 screwdriver. Then proceed to remove the window mechanism and your interior panel. A T20 screwdriver to remove the interior panel and lock module from the inside of door. Disconnect your control module and replace with a new.
How do you replace interior door courtesy lamp?
The past tense of "replace" is "replaced."
If the interior of the oven is stil without rust marks and it is stil in good condition one can replace the magnetron
The blower motor is under the heat box on the passenger side of the interior. To replace it you disconnect the connector to the electric motor then take out 5 screws around the perimeter of the bottom of the blower.
The interior rear view mirror on a Volvo can be replaced by using the mounting kit that comes with a new mirror. The Volvo uses a very strong adhesive pad to connect the rear view mirror to the windshield.
There is a door that diverts the air from the floor to the roof vents. It is controlled with a plastic gear and arm. The gear has stripped out and needs replaced. It's a $35 part but it takes a few hours of labor to replace it because you have to remove so much of the interior to get to it.
If it worked before the regulator was replaced, something was done incorrectly. If it didn't work before the regulator was replaced, the electric motor, switch or wiring may be at fault.
take it to the dealership. part is only about $32, but it needs to be riveted on. This would depend on the model, I had a 1996 Tahoe, and I have replaced interior, and exterior door handles with no problem, none of them were riveted in, all screwed in.
try www.kmuth.com/techsupport/pdfs/21000320.pdf . follow instructions to replace mirror because you need to remove door panel to replace mirror.
How do you replace the clio front passenger seat cable