usually by lifting the seat up. Look at the hinges for a bolt on each side. Take the bolt out and the seat will slide off the pivots. CAUTION!!! You will need an assistant and it will help to remove the front seat(s) first.
The 1992 Chevy K 1500 speed sensor is located on the back of the transmission. The speed sensor will be in the upper right-hand corner of the transmission.
take it to midas muffler
how to remove back brakes on a 2002 Chevy surban
there are eight bolts you have to take out. you have to remove your fuel filler neck and take the ground wire for the tank loose then you have to disconnect your taillight wiring its easier to lift off if you take your back bumper off to
You need to remove the dash in order to get back there to replace any blown bulbs.
Unplug the wire connector and remove the one small bolt that holds the sensor in the timing cover and then pull out on the sensor. push the new one back in the hole and install the small bolt and plug it back up and your done.
drivers side second one back by transmission
It is bolted to the frame and the back of the head. You can put it anywhere as long as it is bolted to the frame and the engine.
You have to remove the gas tank on the back end. the fuel pump sits right where tank connects to the car.
NO. You MUST either put a 1996 or 1997 4L60E back in the 96 model. This is the only 2 years that will work .
front or back speakers? the back speakers, you must remove the rear seat. it is simply held by two bolts on the bottom edge of the seat. once you get them out, there is two torx bolts you must remove. then you will just pick up on the back rest and it will easily come out.
Remove the cover from your 2001 Chevy Silverado stereo. Remove the stereo retaining bolts. Remove the wiring harness and the antenna cable from the back of the stereo.