0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you remove the windshield from a Honda Goldwing gl 1500 cc?
Start by pulling back the trim that holds the rubber boot for the mirrors to the bike. Under the boot you will find a screw that holds the front windshield trim, remove the screw, remove the trim and you will be able to see the mounting screws for the shield.
How do you remove the Interior trim panel for the gate 2006 freestar?
Which trim panel?
How do you remove boot lock on peugeot 205?
Remove the inside boot trim and then pull away the metal clip holding it in. It can then just be pulled straight out from outside the car.
How do you remove the radio trim from a 2006 Chevy Cobalt?
all the trim panels are held in by clips and they just simply snap off
How do you open V40 fuel cap cover manually?
Remove inner boot trim,locate solenoid pin,and pull back.
Is there an element that's red?
my 2006 Honda e is bright red with blk trim. none since that I'm aware of
Vauxhall Vectra boot not opening?
Lock stuck or cable broken. You will need to get into the boot space throught the back seat and remove as much trim as needed until you can see the lock then open it from there manually.
How do you replace the cabin air filter in a 2006 Honda CR-V?
1. Remove glovebox - 2 bolts underneath 2. Remove trim on either side as necessary. 3. Remove aluminum bar - two 8mm bolts at either side of it. 4. Remove filter cover, remove filter. 5. Replacement is a reversal of above procedure.
How do you replace third brake light on a 2006 Mitsubishi eclipse?
You have to remove the interior trim of the lift gate.
How do you change the reverse light on a Ford Falcon gli?
assuming it's an EB/ED GLi! if it's a globe problem. remove number plate, backing trim in boot. remove screws which holds entire external boot trim. globe plugs located on back of external boot trim. dumb idea ford EF/EL: Open the luggage compartment and remove the carpet around the back side of the boot - there are three fittings on the back of the lamp cluster assembly.... can't remember which is the reverse lamp one - usually bottom right (LHS assembly) or bottom left (RHS assembly). Remove those, twist old globe out - then reassembly is reverse of the above! Hope this expansion helps! In the EA/EB/ED you do not have to remove the numberplate, if you just open the boot and remove the backing panel the reverse light bulb holder just screws out. two screws in the backing panel and four pop clips!
Did Honda ever make the 2006 and 2007 Accord in EX-L trim with a 4-cylinder and NO sunroof?
No, all EX models have a sunroof.
How do i remove the stock audio system in a 2006 Chevy Impala LT?
With the help of a Trim Tool, carefully remove the Center Trim Panel from around the Radio. Remove the 4 screws. Pull out Unit. Disconnect Electrical Plug & Antenna. Installation is reverse.....
