0
Its located on the passenger side of the motor its easier if u get under the truck u can see next to the distributer cab just take electrical plug off and remove screw with socket make sure truck is cold saves u alot of burning.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Where exactly is the 2000 Chevy Impala crank shaft sensor?
install 3.8 Chevy impala crank sensor passenger side , remove wheel and use pully to pull out crank shaft
Where is crank sensor located on 2000 Chevy Tahoe?
it is behind the starter. You will have to remove the starter to get to it.
Where is the crank sensor on a 2000 Chevy 3500 6.5l?
It is behind the starter, Will need to remove starter to service it.
How do you remove crank sensor on a 2000 Dodge Intrepid?
Disconnect the electrical connector, remove the mounting screw and remove the sensor.
Where is the crank shaft sensor on a 2000 suburban?
The crank shaft sensor on a 2000 Chevy Suburban is located on the bottom of the engine, near the oil filter. It constantly monitors the crank shaft and updates the vehicle's computer of its status.
Where is the crank sensor on a 2000 Nissan Sentra?
where is the crank sensor located on 2000 nissan sentra
Where is the crank position sensor located on a 2000 Chevy Silverado pick up?
timeing cover lower
Where is the crank sensor located on a 2000 Chevy Cavalier 4 cyl 22L?
Rear of the engine block.
Where is the crank sensor on a 2000 Daewoo matiz?
It is near the bottom of the timing belt in a Chevy. It is part of the ignition system.
Replacing a crankshaft sensor on a 2000 Chevy Malibu 3.1?
24x crankshaft position sensor--remove drive belt, raise vehicle up in front ( car ramps etc. ) remove the crankshaft pulley, remove the bolt and sensor wiring harness retaining bracket. remove the 24x crank sensor mounting bolts, remove the sensor and withdraw the wiring harness. for 3.1 V6 the 2.2 has a 7x position sensor. good-day !
Where is a crank shaft sensor located for a 2000 Chevy suburban 1500?
It is in the passenger side of the timing cover towards the bottom.
Where is the crank position sensor on a 2000 Toyota Echo?
jack up front of car remove left front undercar cover sensor found under crank shaft pully remove connector and measure resisitence of sensor aprox 900 to 1800 ohms
