0
if you dont have the correct puller,you can remove it by tapping the smaller pulley inwards [towards rear of block] with a block of timber,so as not to damage pulley and a 5lb hammer at opposite sides of pulley,example 9 to 3 oclock position.until the small locking cone inside the small pulley becomes loose. you might have to give it a few sharp blows but it will loosen as i have done it a few times.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you remove engine crank pulley 1998 jetta?
Loosen the 18mm bolt about 4 or 5 mm and give the bolt a good wack and the pulley should pop. Then remove the bolt and pulley.
How do you remove crank shaft pulley megane?
To remove a crank shaft pulley you need to first jack up the car. Next, remove the bold holding the crack shaft pulley in place and remove the unit. Reverse direction to put the new crank shaft pulley on your car.
How to remove crank pulley?
On most newer cars, the crank pulley is one piece with the harmonic balancer.... Remove it with a harmonic balancer puller.
How do you remove crankshaft pulley Mazda 626 1993?
Im not sure which direction the bolt turns to remove the pulley...the crank shaft turns in clock wise direction when engine is running.
How do you change front crank seal on 2002 F-150 4.2L engine?
Remove serpentine belt. Remove damper pulley with puller. Remove oil seal.
Where is the crank position sensor on 98 firebird?
On front of engine, lower right (facing front of engine) behind harmonic balancer pulley. It is held on by two bolts (must remove balancer pulley to remove) and is the last item on the wiring harness that runs over the front of the engine.
Where is the crankshaft pulley on a 98 ford zx2?
The crankshaft pulley is the lowest pulley on the engine. Looking at the engine from the front which is looking at it from the passenger side fender the crank pulley is on the bottom of the engine and has a pulley with a pulley behind it with teeth on it.
Water pump location on a 1987 3.0 mercury villager engine?
There is no such thing as a 1987 Villager, I assume you mean a '97. The water pump is in the center of the engine in front, behind and above the crank pulley. To remove it requires that the crank pulley be removed, which may require special tools.
How to remove a RB30 crank pulley?
Use a rattle gun if the engine is out. If its still in the car disconnect the disributer. Put a powerbar and socket on the pulley and lean on the xmember. Crank the engine over over for a split second. Heaps more info on forums. Google it or look on the gtr forum.
How do you replace oil pump on 22re?
it is quite involved it is behind the engine front crank pulley you need to remove the oil pan and the pulley not to mention the radiator to give you some space to work
Where is the crank position sensor located on the engine of a bronco II with 2.9 engine?
it is on the front timing. near botton of crank pulley.
How do you remove the crank pulley on Mitsubishi 3.0 v-6?
remove all belts,tensioners etc, remove pulley bolt, use HARMONIC BALENCER PULLEY to remove - DO NOT USE NORMAL PULLEY REMOVER - must be pulled from center of pulley not from outer edge
