1 1/8"
How do you remove stereo from 2000 nissan pathfinder?
You will need a tool called a puller to remove your crankshaft on your Nissan Xterra. You can purchase this toll at most auto parts stores, or borrow one from a shop or another mechanic.
Hello, I am copying the answer from my Nissan Pathfinder repair Manual. This is for 2.5L and 3.3 L engines, NOT THE 3.5 L ENGINE!!! 1- Disconnect Negative cable from the battery. Rause the front of of the vehicle and secure it on jackstands. 2. Remove the engine under cover. Remove the lower radiatorshroud and remove the engine colling fan. 3. Remove the drivebelts. 4. Use a strap wrench around the crankshaft pulley to hold it while using a breaker bar and socket to remove the cranshaft pulley center bolt. 5. Wedge a prybar or two screwdrivers behind the crankshaft and carefully pry it off the crankshaft. If the pulley is difficult to remove, use a jaw-type puller and pull it off. Installation is the reverse of removal. Tighten the pulley bolt to the torque listed in the manual, then adjust drivebelts. Hope this helps-S
how you can remove the knock sensor from a 1996 Nissan pathfinder i need a picture
What tools do you need to remove the crankshaft pulley on a 1995 Honda Passport?
Depending on engine displacement in general remove belt-s then bolt holding pulley to the crankshaft then using a puller remove the pulley, when installing use a installer not a hammer to put the pulley on the crankshaft.
u need to buy new pulley then, remove serpentine belt from engine remove bolts that hold pulley to crankshaft remove pully instalation is exact opposite of removalAnsweru need to buy new pulley then, remove serpentine belt from engine remove bolts that hold pulley to crankshaft remove pully instalation is exact opposite of removal Answeru need to buy new pulley then, remove serpentine belt from engine remove bolts that hold pulley to crankshaft remove pully instalation is exact opposite of removal
The crankshaft pulley unbolts from the harmonic balancer. The harmonic balancer can be removed from the crankshaft with a 3 bolt puller.
how to remove a power steering pulley on a 1997 Nissan altima
Hello! The crankshaft position sensor is located behind the crankshaft pulley,on the left side facing the front of the car.It is difficult to see and to remove it you need to remove the crankshaft pulley ( radiator,belts,.... )
Remove crankshaft pulley& ballance