Carefully. Try using either a shop vac with a small end (improvise an end if you have to with some hose and some Duct Tape or something), or try compressed air (be sure to protect your eyes).
Remove the spark plug wire from the spark plug and make sure it will not touch the spark plug. Or, you can remove the spark plug, but be sure and cover the hole so no debris will fall into the cylinder.
You have to pull the coil packs under which you will see the plug wire. Down in that hole is the spark plug. Caution, please blow out all debris before removing plug from the block.
If you are referring to the 4 cyl engine, there are caps covering the spark plugs and you can remove the caps with a Philips head screwdriver. Gently pulling the plastic up will reveal the rubber hole cover and the spark plug hole.
If you mean that the wire came out of the boot, then pull the boot off of the spark plug and use a spark plug socket to remove the spark plug.
Um, you probably shouldn't have had glass around the open spark plug hole in the first place. this could make it hard for your spark plug to fit into place, or even send the spark to the cylinder. You will have to take apart the head and remove the glass depending on how big the shard, or piece is.
Remove the coil pack for each spark plug, then reach inside the hole with a ratchet extension and unscrew them.
To change the spark plugs in a Chevy Celebrity: 1. Give the spark plug boot a twist to free it up from the spark plug, then pull on the boot to remove the spark plug wire from the spark plug. 2. Use a 5/8" spark plug socket with an extension and ratchet or breaker bar to loosen then remove the spark plug. 3. Set the gap on the new plug to .045" then screw it back into the spark plug hole in the head. Tighten the spark plug and replace the spark plug wire. I change the spark plugs one at a time to keep from getting the spark plug wires on the wrong spark plug.
Remove the spark plug/s and crank the engine over with the plugs removed.Be sure to keep the plug wires away from the spark plug hole so they do not ignite the gas that blows out of the spark plug hole.Dry off the spark plug/s and reinstall or install new plug/s.
If you have access to a spark tester, use it. Otherwise, remove the spark plug, reconnect it to the spark plug wire, and rest the tip or threads on a good engine ground, AWAY from the spark plug hole. Attempt to start it, and watch for spark. If none, replace the spark plug and try again. If still no spark, the magneto coil may be faulty.
If you have access to a spark tester, use it. Otherwise, remove the spark plug, reconnect it to the spark plug wire, and rest the tip or threads on a good engine ground, AWAY from the spark plug hole. Attempt to start it, and watch for spark. If none, replace the spark plug and try again. If still no spark, the magneto coil may be faulty.
no, it takes the same socket as the others. most likely something is down in the hole next to the spark plug
Remove the spark plug wire. Using a 5/8" spark plug socket with appropriate extension and driver unscrew the spark plug and remove it. The spark plug gap should be set to .045". Replace spark plug and reattach wire.