The OUTER door handle is held in place with two pins. Lift slightly on the handle and look under the two castings on the side. Note the pins that are holding the handle to the door operation mechanism. Push the pins out using a small rod then slide the handle off the mechanism.
You will need to remove the inside door panel. Remove the door handle retaining screws. Remove the linkage from the back of the door handle.
I don't know - but the question about the 1993 door handle is the same...
how to remove a sunroof in a 1998 Saturn 4 door sedan
Lift the door handle as though trying to open the door. You should see two pins going through the handle assembly. The pins can be pushed out, allowing you to remove the handle.
Remove the door panel
If it's the outer handle you would need to remove the door panel, then remove the rivits that hold the handle to the outside of the car. Then remove the window track and slide it down inside of the door and unhook the rod on the handle,and now you can slide the door handle out.
You have to:Remove the door panel.Undo the rods off of the handle.unbolt the door handle from the inside of the door.
Should be able to access after removing inner door panel
Since this question is in the Saturn area, it must be assumed that you are asking about removal of a Saturn door panel. The inner door panel of a Saturn is not removable, it is integral to the door frame. However, you can remove the outer door panel. First, remove the outer door handle; lift the handle enough to reveal the pins that hold the handle to the door latch mechanism, then press out the two pins and set the handle aside. Next, open the door and remove the screws around the perimeter of the outer door panel. After the screws are removed, the outer door panel should lift off easily.
remove the outside handle by lifting the handle up and removing the small clip in the underside of the handle The inside door handle? remove the screw pull towards the front then out and release the clips holding the lock and open rods
you need to remove the inside door panel to get access to the inside, remove the clips holding the door handle assembly and the whole thing comes off
The interior door panel cannot be removed from the door. To work on the inside mechanisms of the door, remove the outer, plastic skin. First remove the outer door handle; lift the handle enough to expose the two pins that hold the handle to the door mechanism. Push the pins through and remove the handle. Next remove the screws around the perimeter of the door. They are visible when the door is open. After all of the screws are removed, lift the outer door skin off and you have full access to the inside of the door.