Well, I'm assuming you got the motor and trans out in one piece. If doing this in the vehicle be prepared to cuss, a lot. Simply take the nuts off the studs around the bellhousing, there should be something like 9 of them but it's been awhile since I've had a 4L60E out. Unbolt the 3 bolts from the torque converter (you have to take the cover off the bottom of the bellhousing to access them, and you'll need a prybar to hold the flywheel in one place unless the motor is locked up). If you don't take these 3 bolts out, no big deal except when the torque converter pulls off the imput shaft you will spill fluid everywhere. Disconnect any wiring harnesses, and don't forget about the dipstick. Now, was that really that hard?
The engine oil drain plug is located at the lowest point of the engine oil pan. It should take a 15mm wrench to remove it.
6 on each wheel
It is in the gas tank.
Chey Pribel goes by Chey.
Chey's population is 613.
CHEY-FM was created in 1990.
The area of Chey is 22 square kilometers.
Chey Pribel is 5' 5".
Drivers side aka, left side.
forget the chey and buy a new ford
Try 1,8,4,3,6,5,7,2, this is for most chey V-8's
i have never heard of chey