Want this question answered?
remove battery cable for 1 min
You have to remove the engine mount next to it, then remove the 4 bolts in the pulley
There is 2 of them in the back of the engine. You will have to pull the engine are remove the transmission and fly-wheel to get to them. It is what ever is the easiest for you.
inside of van in vicinity of heater core. to remove, remove battery from engine bay to access bolt that holds it in place
Not very easily if at all, and why would you want to?
Disconnect batt. Drain Raidiator coolant.Remove Dashboard. Unhook both heater hoses located on firewall in engine compartment. remove airbox nuts in engine compartment. remove retaining screw for core in cabin. remove core.
the oil drain plug is located near the frame, below the oil tank where the swingarm meets the frame at the bottom of the frame on the right side. There is no engine drain location as the engine is a dry sump system meaning there is no oil stored in the engine other than residual oil.
I found that if you drop the hole engine and cradle from the bottom of the car it is much easier
The 1991 Mercury Capri engine is not an interference engine
To replace the clutch disc in a 1991 Acura Legend you must first remove the engine from the vehicle. Loosen the pressure plate by adjusting the bolts and remove. Put the new one where the old one was and tighten the bolts.
how many engine mounts are there on a 1991 corolla.
No. A 1991 Plymouth Acclaim does not have an interference engine.