0
How do you remove engine strut mount bracket on Chevrolet Venture?
Wiki User
∙ 11y ago
remove the top bolt it is easy to see, next there are two long bolts going through the compressor at the bottom of the engine left front they can be seen from under the van! this was hard for me to find!
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How do you change the head lights on a 2000 Chevy Venture?
There are 3 wing nuts holding the headlight bracket. Remove these and unplug wire going to headlight. Remove bracket from van and then the headlight can be removed from bracket.
How do you remove a 2002 Chevy Venture alternador answer with pictures?
como sacar el alternador de chevrolet venture 2004
How do you reset computer on Chevrolet Venture?
remove the positive battery cable for about 20 min.
How do you remove radiator drain plug on 1998 Chevrolet venture?
If it is a plug -- turn it counterclockwise to remove If it is a "petcock" turn it clockwise to open
How do you remove sun visor from 2003 Chevrolet Venture van?
Remove the 3 screws and pull the ring down -really hard-
How do you remove an alternator bracket on a 1998 Dodge Caravan 3.3 Liter engine?
remove belt, remove alternator plugs, then bolts. pull out alternator. then undo bolts for bracket and remove.
How do you jumpstart a 1964 Chevrolet?
Install the positive cable to both batteries. Install one cable end to the battery and the other end to the engine bracket of the other car. Remove the cables in the reverse order.
Is it easy to change the Chevy venture 2000 model headlight unit If yes then you will appreciate if some one can tell you the steps involved thanks in advance?
There are 3 wing nuts holding head light bracket, remove these and unplug wire, lift out bracket, then remove headlight from bracket.
How do you change timing belt on 1996 Chevrolet Cavalier?
First you should pull the belt off of the pulleys and out of the engine bay. Next, remove the power steering mount without disconnecting it. Next, detach the alternator wires and remove the alternator bracket.
How do you remove the old clutch in a 1985 Fiero?
Basically 1 Hang the engine from a bracket that runs over the top of the engine bay 2 Remove the rear tires, and brakes 3 Remove the two rear axle shafts 4 Remove the engine cradle, with the engine supported by the top bracket 5 Remove the transmission that is hanging with the engine 6 Remove the pressure plate, and clutch, and flywheel from the hanging engine Installation is the reverse of the above
How to replace alternator bracket gasket on 2005 BMW 545i?
remove the alternator, remove mounting bolts for steering pump and position aside, remove upper engine mount bolt/nut, support engine with sling, remove the upper engine mount bracket, then finally accessory bracket. whole job with proper tools and equipment takes approx. 5 hours to do. I would not attempt to do this as a driveway repair.
How do you replace the water pump on a 1990 Dodge Daytona?
Suport engine with a jack under oil pan..remove top right motor mount..remove two bolts that hold POWER STEERING PUMP to the engine bracket..remove bolt that holds BELT TENSIONER to engine bracket..3 or 4 more bolts that hold ENGINE BRACKET to ENGINE..remove ENGINE BRACKET from ENGINE..remove TIMING COVERS..Loosen TIMING BELT TENSIONER...Release SPRING...(Water pump is driven by the timing belt) Remove Timing belt..Remove Water Pump...replace...RE-TIME!..Put back together..be sure to RE-TIME, if you want the car to run again, anyway.. Not an easy job..I hate working on this car.
