Want this question answered?
Remove the belt, then remove the bolt holding in the idler pulley.
Which pulley are you referring to. There is 5 or 6 on that car.
Remove belt. Remove the bolt and then pull the pulley off. Put new pulley in position. Put the belt back on.
You need to remove the bolt, insert the special tool in the hole, and install a three jaw puller to pull the pulley off.
It requires a power steering pulley PULLER, You can rent them at a parts store.
You have to unscrew the tensioner bolt and remove the serpentine belt first, then change the pulley and replace the belt.You have to unscrew the tensioner bolt and remove the serpentine belt first, then change the pulley and replace the belt.
Check with your local auto repair shot to see if they rent tools. If so, they likely carry a crankshaft pulley remover. I'm in the process of changing the water pump on my 2002 Intrepid and I rented the tool. Now I have to find the installer because the one they had didn't fit my pulley.
You can remove the old serpentine belt on your 2004 Dodge Ram by loosening the tensioner pulley. Put the new serpentine belt on and tighten it with the tensioner pulley.
With a 36mm wrench and a spanner to hold the water pump pulley.
loosen the idler pulley and then remove the belt. then you remove the fan shroud i believe its like 4 bolts, then you remove the fan. after that you can remove the water pump.
You will need a special 3 jaw puller and an insert for the puller to push against.
You need a special tool to remove the crankshaft pulley on a 2003 Dodge Stratus. The correct tool is OTC Tool No. 6075. If you don't want to buy one, you can rent one from an AutoZone store.