Want this question answered?
The push pins that are holding trim to the front bumper on a 2001 Silverado are actually pop rivets. These rivets have to be cut off to remove them. A hacksaw will be needed to accomplish this.
== == == == you don't it's molded int to the bumper.
There are a flat head nuts on the back side of the bummer, you will need to remove these nuts then pull the bolts out. the bumper (if it has not already done so) the bumper will fall off. If you also wish to remove the braces you can do so just as easily.
# Support bumper with a jack or jackstand # With an assistant supporting the bumper remove the bolts,nuts and stud plates retaining the bumper to the frame # Disconnect any ireing harnesses or any other components that would interfere and detach the bumper
The front bumper for a Lincon Navigator cannot fit in an F150 2001 SVT.
The horn is located in front of the right tire. You have to remove the plastic cover in front of the tire to get to it. You should be able to see it through the vent on the front bumper.
On my 2000 grand cherokee, It was in front of the battery on the fender wall. Remove battery and you should find it. It is under the bumper cover, under the passenger head light. You either have to remove the front bumper, or you remove the headlight and cut an access hole.
There are four Torx head bolts that hold the bumper to the frame. Two on each side, one on top and one on the under side.
how to 2001 highlander grille
how do you screw off front bumper to a land rover discovery 2001
First remove the front clip (headlights and grille and plastic covering the bumper.) The rest will be obvious.
repair manual fora front differential on a 2001 ford ranger edge