== == == == you don't it's molded int to the bumper.
A person can remove the front license plate cover on a 1990 Corvette with a screwdriver. The plate can then be replaced with a custom plate or a state plate if required.
On the drivers side in front of the cross member. You have to remove the black plastic cover to get to it. It faces the front of the car.
There are screws holding it on. Un-screw them.
Lay down on the ground in front of the cover,look between the cover and the bumper and you'll see two Phillips head screws.remove them and your cover will be off.I just did this.
Remove bottom of the license plate cover by slowly pulling outwards. It is glued with a HEAVY 3m tape. The top of the cover is different it has 3 hidden tabs across the top. Slide a flathead screwdriver down from the top of the cover and slowly work each tab out of its slot. There is on the upper left and right and one in the middle.
you have to pull the front motor mount off the core support, then voila, easy as pie from there
There are two screws on the bottom of the cover. You should have just enough room to fit a screwdriver in between the nose of the car and the cover without scratching the paint. It might be tight, but the cover should give enough for you to get tools in there.
Are there people that use the front license plate still? lol Well taking them off if you are using them is quite easy, get a screwdriver and take the bolts out. Now if you have a custom plate holder you can get a detailed answer by visiting smokinvette.com. Good luck!
pull front of rear seat up. remove it and battery is right there
In the back of the seat (both) you have a star screw bit that one you remove it you lift up on the back of the seat and the front will come up out of a groove that it slides into.
front right hand corner of engine compartment under a plastic cover and under rear seat.
Remove the screws in the wheel wells and underneath the plastic cover to remove the bumper cover. Then you can see to remove the actual bumper.