Want this question answered?
== ==
Pop the hood. Remove the front shroud cover to expose the radiator and light assemblys. Remove the head lamp assembly by removing the vertical light brackets. These brackets are vertical metal holders for the lamp assembly. They are removed by pulling up and there are two per side. You will see them once you remove the front shroud cover which exposed the light assembly's. The light brackets will have hard rubber attached to the top on each one to facilitate their removeall. Once you have removed the brackets, the entire light assembly will slide forward. You will need to guide the wiring so that you can slide the light assembly forward. Once you have the entire assembly slid forward you can remove the light socket from the back of the assembly and change the bulb.
Remove the fasteners and electrical connection from behind the assembly and slide the assembly out the front.
You have to remove the front bumper, remove the headlight assembly. then take the fog light bulb out.
remove front headlight assembly to get at horn,it is down below light assembly..
Remove the headlight assembly and you will have access to the parking light bulb.
there are 3 pull tabs on each light housing. lift up and remove all 3 and simply pull out the complete assembly very easy
Front Fog Light AssemblyREMOVAL # Disconnect the ground cable from battery. * Remove the two clips and lower mudguard. * Disconnect the harness connector. Remove the lower bolts. # Remove the mounting bolts and clip, and then detach the fog light assembly. INSTALLATIONInstall in the reverse order of removal. Front Fog Light BulbREMOVAL # Remove the front fog light assembly. Remove the back cover. # Remove the spring retainer, and then detach the fog light bulb. INSTALLATIONInstall in the reverse order of removal.
3 10mm bolts hold on the headlight assembly. Remove bolts and lift assembly slightly from the bottom to release it. Pull assembly forward. Twist marker light holder to remove it. Bulb pulls out. Reverse for installation.
you must remove the front grill assembly, then you should be able to do it, just need a screw driver
You have to either unscrew and remove the lens or disengage the bulb and socket assembly from the rear of the lens housing.UpdateThere are two vertical light brackets that hold the entire light assembly in the car. These are removed by pulling up. You can identify them by first opening the hood and removing the radiator cover that also covers the lights. Once you pull up and remove these two holders, the entire light assembly will slide forward. You will need to guide the wiring harness to allow the light assembly to move far enough forward to gain access to the rear of the assembly to change the bulb.
You will need to remove the tail light covers in the cargo compartment. Remove the wiring harness. Remove the tail light assembly retaining bolts.