Want this question answered?
Mercury capri glove box light.
The blower is behind the glove box. Remove the glove box door, and there it is. Some small sockets will be in need. It will come out if you wiggle it around.
Open the glove compartment and remove it. Disconnect the electrical connector and the three mounting screws. Remove motor.
push up the rods that the hand connected to and pull down... it gets easy after a while... they make repair kits... and gorilla glue is sold and walmart :)
Remove the glove box. The front blower motor and the resistor can be accessed from there.
On the blower housing. Remove the glove box to gain access.
how to remove my glove box
how to remove glove box in 1993 camry
Look up under the handle and there's a hole perpendicular to the front of the glove box. Insert a small screw driver about an inch into the hole and pry gently towards the back of the truck which should release the glove box. It takes some encouragement, but remove the 2 screws holding the latch (from the inside of the glove box) and the latch should come free out the front.
2008 lacrosse glove box
Assuming it's the same as a 94 C1500, Open the glove-box, remove the screws across the top and bottom, remove the cables that support the glove-box door, remove the glove box door, remove the glove box compartment. I have a 95 K1500, you just have to squeeze the top of the glove box, clear the mount and then remove the plastic strap on the left side, and then open the glove box fully it just fall down, no need to unscrew anything.
Annoyingly, this requires some dashboard dismantling. Remove the fasia, dials, lower dash and kick pannel. The bolts to the door hinges are now visible, though still difficult to get to. If it's the paasenger side, then just the glove box and kick pannel I guess.