Want this question answered?
Step 1 - Remove the plastic trim around handbrake by pulling it up from the rear it will unclip. Step 2 - There is a 10mm nut you can turn this to adjust the handbrake. A good idea is to park on a flat and then see if the car can be easily pushed with the handbrake released. Step 3 Once the handbrake is adjusted to the correct amount replace the trim and firmly push down on it so it clips back into place. If you find this method does not improve your hand brakes effectiveness you will need to get you rear calipers checked as they may be fualty.
It is located on the firewall in the passenger's footwell. You have to remove the trim panel under the dashboard to see it.
Remove the liftgate inner trim panel.Remove the liftgate inner trim panel.
The push pins that are holding trim to the front bumper on a 2001 Silverado are actually pop rivets. These rivets have to be cut off to remove them. A hacksaw will be needed to accomplish this.
Look at lower end of the shifter (may have to remove trim for access)
pry the trim piece surrounding it straight off. that will expose the four screws which need to be removed. bend down the two metal tabs and remove module
open the door, remove door trim and the torque screw holding the strap to body, and two nuts holding strap to door and remove door stop from inside door
the r has a few trim upgrades and runs slightly higher boost
remove trim around clocks, remove clocks, replace bulb in back. hope this helps
1.Remove the front door trim panel.Remove the speaker retaining bolts.Disconnect the electrical connector and remove the speaker from vehicle. Installation is the reverse.
# Remove the center console # Detach the retaining screws from the center trim panel.Disconnect any electrical connectors and remove the trim panel
Pulse is Green/red trace behind the stereo. Remove trim from around Handbrake, then lift the trim around the handbrake, access then to two screws at base of radio facia. Remove glove box (pull sharply to disengage). A third screw, which goes into side of radio can then be removed. Whole facia, complete with radio and air vents can now be pulled forward to expose connector at rear of radio. Green wire with red trace gives a pulse of 4k