There are 2 I think they're called "fast clips" or something like that. You just have to pull them straight up. They're mentioned in the cars manual, but it doesn't show what they are. They're located at the adjustment screws, I'm not sure if you have to take that upper cover off or not (I took way more off then I had to since I didn't know how it came out the first time). Anyway, don't adjust or take out any screws it won't help. You just have to find those tabs and pull them out with a pair of pliers. I was very confused when replacing the bulb too. Its a PITA design in my opinion.
Remove the wiring harness from the back of the headlight. Remove the headlight assembly bolts. The headlight assembly will come out.
it is behind the passenger side headlight assembly. you will have to remove the headlight assembly to replace it.
8mm
Open the hood, stand in front of the effected headlight, notice the two tabs sticking up behind the radiator support in back of the headlight assembly. These tabs are locks that hold the headlight assembly in place. Lift the tabs up and remove them. Now you can wiggle the headlight assembly out the front and remove the bulb. Reverse for assembly.
remove front headlight assembly to get at horn,it is down below light assembly..
Open the hood. Remove the black plastic cover that goes across the top of the headlights/radiator. Remove the two silver screws that are on the top of the headlight assembly. Then remove the light housing...Not much holding them on.
*** Should be under the passenger side headlight, behind the bumper. Remove the headlight assembly & you might find it...
Remove the headlight assembly to gain access to the bulbs.
Undo the hex nut on top of the headlight assembly and remove bolt. Grap bottom front of headlight assemby and pull hard upwards causing the bottom pins to release then pull directly outwards to release the top pins. Turn back of globe anti clockwise to release globe from headlight assembly.
Stand in front of the headlight in question, with hood open notice two black tabs sticking up behind headlight bucket assembly. Remove the two tabs by lifting straight up. The headlight bucket assembly can now be wiggled out of the car and you can now remove the bulb socket from the assembly to replace the bulb. Reverse order for assembly.
Remove the headlight assembly to gain access to the bulbs.
you have to remove the turn signal light and some of the trim (grill) to get to the screws that hold the light assembly in place. 10 minute job.