Open the bonnet and unclip the front grill, it just pulls up and out. The headlights are secured in with three Torx screws, for these you either need a torx screwdriver or a very large flat screwdriver which can go across the top. Undo the three screws and then just pull the headlamp out. to remove the bulbs, twist the covers at the back.
I've done this job on a few occasions now, once you have done it the first time its easy! But a word of caution, I have failed the M.O.T twice on headlight alignment because of this. When you put the headlight assembly back in position, it is out of alignment! Pain is the doo dah!!
To remove the air filter on the Fiesta MK6, first remove the bolts on the top of the air filter box. Then, pull upward to remove the rubber gasket around the box. Remove the screws at the rear of the box. Remove the filter and replace it.?æ
the mk6 fiesta 1.25 has 75bhp.
Open the bonnet. Remove the grill. Remove the screws holding the headlight in. Carefully pull the headlight out. Remove the cap on the rear of the headlight.
Depends on the engine. A variety of different petrol engines and a diesel option were fitted to the Fiesta Mk6. All have different filters.
Mk6 1.4 Duratec SE 16v 02> gap should be 1.3mm.
Nope, pins are different.
in the door panel and in the the rear side panels. hope this helps
Yes they will all fiestas from mk4 to 7 as far as i know all have the same 5.5mm space of alloys
5" X 7", & aparently 20 watts each
Take it to a specialist, I've looked on here and nobody knows!
Yes,the mk4 and 5 chassis' are identical and generally any fiesta front wheel drivetrain can be transplanted into any other fiesta engine bay up to mk6.
All you will need to change the bulb is a screwdriver and a new bulb. Remove the headlight cover using the screwdriver and remove the burnt out bulb. Once out, you can insert a new bulb into the slot and replace the headlight cover.