Want this question answered?
you have to remove the dash
Unbolt and remove
just pull the ashtray all the way out and remove the screws on the sides.
Work inward in a circular motion.
Disconnect - battery terminal Raise and support vehicle Remove wiring harness from starter Remove mounting bolts Drop starter
Email me at:shughes@gcronline.com. I will give you what you need to know. Lynn
The 1992 Plymouth Cold ignition switch is held in place by a retaining ring. Remove the retaining ring at the top of the ignition switch. Pull the ignition switch out. Remove the wiring harness from the ignition switch. Reverse the process to install the new ignition switch.
The first step is to unhook the battery.
Remove fuel filler cap - turn on ignition and listen for "hum" Check fuel pressure - with key on engine off should read 23-31 psi.
1Disconnect negative battery cable. Remove the 3 bolts attaching the starter to the engine/transaxle. Remove the heat shield and its clamp, if so equipped. Remove the 2 electrical wire connector terminal nuts and remove the wiring connectors from the starter. Remove the starter from vehicle. Clean all wire terminals of dirt,grease or corrosion. Reattach the electrical wire connectors and secure with the mounting nuts. Tighten the starter solenoid B+ nut to 80 inch lbs, and the solenoid wire to starter nut to 55 inch lbs. Reinstall the heat shield if one was removed.
Disconnect - battery terminal Raise and support vehicle Disconnect wiring at top of starter Remove mounting bolts Remove starter
Chevy Tahoe Ignition Key Starter Switch