Want this question answered?
You can remove the injector, on your C 12 Caterpillar diesel engine, by removing the injector rail. Remove the retaining nut and the injector will come out.
Cracked injector cups is the main cause of diesel in the cooling system. There is a special tool to remove them with out taking the head off.
rear valley of the engine under the turbos. must remove the cab to get to it.
u need a torque rench with your injector torque settings, they are on the side of the head built in in the 2.5 tds isuzu engine
You have to remove the glove compartment.
An excerpt from the manual: 1. Remove the air cleaner assembly and attached hoses. 2. Remove the injection lines from the fuel distributor and the injectors. 3. Remove the mounting screws and injector retainers. 4. Pull out the fuel injector. 5. Remove the rubber sealing ring. 6. Reinstall in reverse manner. Hope this helps
Removing the injector is fairly simple. There is a fuel supply line (steel line) to each injector. There is also a return line (smaller one). Both of these lines will have to be removed. On the return line be careful not to lose the little compression washers. Remove the two bolts that hold the injector in place. The injector should pull out. Be careful not to lose the copper washer that usually comes out with it. Inspect the end of it. There should be tiny holes in the end where the fuel sprays out. Unless you have a injector tester you will have to take them to a Diesel mechanic and have them tested. They will hook them up to a machine that can apply the PSI required to see if they are working properly. It shouldn't cost that much.
How do i remove a shifter on a mercedes
Remove pressure from the fuel system. Remove fuel lines and the rails. Get a fuel injector puller to avoid the risk of damaging the injector. Remove the old injector and replace it.
Find them and remove them
how to remove fuel injector plug in on a 2007 chevy suburban 5.3
how to remove subwoofer on mercedes s430