Want this question answered?
blower motor is under the passenger side dash board 3screws and it comes out there should be a ta on the fan pry it out towards the finsof the fan and the fan should come off might want to spray with some wd40 should help probable on there rilly tight
In the trunk of your car lift the "floor" (Carpet & press board) you will see 2 round sealed ports, in the back close to the rear seat area. I'm pretty sure it is the one on the left. Remove the seal and just pull up the pump. I know it is that easy.(My daughter did it herself)
The computer (ecm) is under the passenger floor board under the carpet. will have to remove medal cover.
The heater core has gone bad if there is coolant in the interior of the vehicle. The heater core is a small radiator that is located in the dash board. It radiates heat from the engine coolant into the interior of the vehicle.
There is a circuit board that costs 773.00 from the dealership. Best bet is to find one at the junk yard to save cost. But first check all fuses. If they are all good that will be your next step.
It's on the front passenger floor board....Disconnect Negative battery terminal. Remove the carpet from the top. Remove the ECU cover. Remove the ECU retaing screws. Disconnect the connector and pull out the ECU..........Installation in reverse.....
under the passenger side of the dash board, remove the plastic insert up on top mate for the secondary fusebox
under the passenger side of the dash board, remove the plastic insert up on top mate for the secondary fusebox
Supposedly, there is a main relay (located in driver's compartment, under dash?) that gets "distant" when it gets hot. The engine will crank, but that's it. Solution is to replace main relay (Dealer>$70), re-solder every connection in the relay/circuit board to eliminate whatever connection is cracked (& heat spreading), or air out the interior of your car until it is cool enough to fool the main relay . . .
Ask a Loacl. HOW do you remove the dash board on a 1996 dodge avenger
Remove the plastic cover going around the board. It sits on clips. After you will see 4 screws holding the board. Remove them too. Pull out carefully the board, disconnect 3 wire harnesses.
the interior fuse board is behid a pocket just under the electrick mirror controll. just pull the pocket out/ it clips in and out. and there behind it is your fuse board