0
Window height may need to be ajusted to gain access to lock cylinder. Remove the two screws by the interior handle to remove the cover plate(one under the handle, one under the fiero symbol). Remove the three fat screws for the arm rest. The interior door panel is just fastened with plastic clips, but they have a tendency to pull out of the pressed fiber panels so use caution. Once the inner door panel is removed you should be able to see the linkage attached to the lock cylinder. It's held on by a small retaining clip. Take a small screw driver and pop it off(it's gonna go flyin so pay attention) and remove the linkage. Just ahead of the lock cylinder(1/2 inch) you will see an inch high piece of metal sticking out(usually, but not always, rusty). Pry forward to release. Once removed, push the cylinder in from the outside. Done. Hope this helped.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you remove door lock assy on the driver side of a mercedez Benz 190 E?
Remove the drivers side door panel of your Mercedes-Benz. Remove the door lock assembly retaining bolts. Remove the door lock linkage. The door lock assembly will come off.
Remove a rear door lock from a 97 Plymouth grand voyager?
Begin by removing the inside door panel on your 1997 Plymouth Grand Voyager. Remove the door lock linkage. Remove the door lock retaining bolts. The door lock will come out.
How do you remove the door lock on 2000 dodge neon?
how to remove a door lock cylinder on 2000 dodge neon
How to Replace key door locks on a 2000 escalade?
Remove the inside door panel of your 2000 Cadillac Escalade. Remove the door lock linkage. Remove the door lock retaining bolts. Reverse the process to install your new key door lock.
How do you remove the lock in the cylinder on a 1986 Mazda B2000?
what lock cylinder?door or ignition? door is simple, remove inner door panel, unhook rods attached to lock cylinder, remove retaining clip
How do you remove door lock?
remove inner door panel for access to lock
How do you change the door lock on a 1999 vw jetta When I turn the key nothing happens. Are there any troubleshooting steps to take before replacing the whole lock assembly?
Remove the inside door panel. Remove the door lock linkage. Remove the door lock barrel retaining ring. Reverse the process to install the new door lock.
Where is the door lock actuator on an 02 Chevy tralblazer?
You will have to remove the door panel. And it will be mounted over by the door lock on the inside of the door.
How do you pull an ignition for 1984 Pontiac fiero 2m4?
Remove steering wheel Remove Steering lock plate Place ignition in on position Depress lock pin now exposed. If this is not possible, drill out lock pin.
How do you open my rear trunk on my 1986 fiero the lock has been broken off?
The lock has a clip on the inside, pull the clip off and the lock will come out, remove the lock rod and then you can use a screwdriver to open the lock.
How do you remove passenger door lock cylinder to replace the power door lock?
First remove your door panel and interior lock module modular with T30 screwdriver. Then proceed to remove the window mechanism and your interior panel. A T20 screwdriver to remove the interior panel and lock module from the inside of door. Disconnect your control module and replace with a new.
How do you remove ignition switch from steering column on 84 Pontiac fiero?
you have to remove the steering wheel then using a lock plate removal tool depress the lock plate and removed the clip that holds it in place then remove the lock plate then remove the screws from the turn signal switch and pull it up slightly then remove the screw that hold the lock cylinder in place then remove the lock assembly
