in the boot where the back of lights are you will peel back a cover.disconnect the wiring plug then use a flat screwdriver depress the lugs at the top/bottom of the light unit and then be careful and push the unit out from the boot.Be ware that it doesnt fall out onto the road.
yes you can get them for a few quid 2/3 pounds
how do i replace a h/lamp bulb on citroen c2 o/s.or easy way to remove headlamp
no because when you remove the lamp the circuit is still open; even if the switch is on
At the back of the lamp, take the air filter pipe out, then when that is out of the way, remove the black 3 inch round plastic bulb cover by unscrewing it. Inside there, you will have to stick you fingers in and pull a holder out and it is has a push fit lamp quite a bit of a game mind.
If it's just the bulb you are replacing it is done by removing the indicator (unhook the spring in the engine compartment and slide the indicator forward). If you need to replace the whole lamp then the bumper has to be unbolted!
tke a screwdriver and remove the screws and take out the tail lamp. otherewise take a hammer and break the tail lamp
Remove two rear lamp bolt/screws from rear license lamp. Remove lacense lamp from rear bumper fascia. Remove license lamp bulb and socket from rear license lamp. Replace bulb and install using reverse procedure.
== # Remove screws attaching license plate lamp to rear bumper # Remove lamp from bumper. # Remove bulb socket from lamp. # Pull bulb from socket. == # Install bulb into socket. # Install bulb socket into lamp. # Place lamp in position. # Install screws attaching license plate lamp to rear bumper.
Away from the lamp to remove hot air. This way you are not blowing unfiltered air and dust on lamp.
sounds funny but check your brake lamp switch at the top of the brake pedal as the computer will reduce power to the low pressure fuel tank in the boot - this is activated by the brake pedal - so check correct operation of your brake lights & bulbs this will give first clue. other wise the usuals like fuel filter etc
# Release decklid latch and open decklid. # Remove trunk lining from rear closure panel as necessary to gain access to tail lamp fasteners. # Remove nuts attaching tail lamp to rear closure panel. # Remove tail lamp from rear closure panel. # Remove socket(s) from tail lamp unit. # Pull lamp from socket.
HOW IS BEST WAY TO REMOVE BULB ON THE GMC CANYON FOR LICENSE PLATE LAMP ?