There are special tools to assist you with that problem but some times the wire and or the boot gets damaged anyway. But sure to use dielectric grease on the boots to help avoid that situation next time.
mike
Ozzy Osbourne plays the guardian of metal if that's what you mean. I haven't heard of the protector of metal unless that's another name for the main character, Eddie Riggs played by Jack Black.
Remove the passengers side front seat. remove the metal engine cover after pulling carpet back, remove the long metal cover covering the spark plugs and wires.
It is called a horse shoe.
Ozzy Osbourne plays the guardian of metal if that's what you mean. I haven't heard of the protector of metal unless that's another name for the main character, Eddie Riggs played by Jack Black.
Follow the top radiator hose from the radiator to the engine. At the engine there will be a metal housing. Remove the housing and the thermostat is right there
remove top engine mount and cut off metal lug that stops engine from lowering enough to remove harmonic balancer. Then engine lowers enough.
Remove gas tank and plastic shroud covering engine. Remove metal engine shroud and debris screen. Starter pulley and recoil assembly are underneath screen.
AnswerTo remove impurities and metal filings that are normally produced as an engine wears from lubricating oil to prevent further wear on engine components
Just follow that top hose leading to the engine. Remove that metal pipe attached. It's right there.
its located on the top front of the block there is a metal pipe connected by two bolts. remove the two bolts and it is right at the end of the metal elbow.
if i was to remove metal i would use pliers