0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you fix a jammed weed wacker?
Stop motor. Remove line spool. pull spool from shaft and remove cord or weeds from around shaft. Replace spool on shaft. Re start motor.
Wix 51358 to fram?
Fram XG7313/TG7313
How do you wind new weed eater string on an old spool?
pull straight out to remove the spool, wind in the direction of the arrow - to replace, feed the string through the hole and pull on it, keeping slight tension on the spool as you push it back into the head
How do you install 065 cutter line on Weedeater model RTE 115 trimmer which you have only been able to find prewound spools at Lowe's?
Unscrew cap and remove. Remove line guide ring. Note which way to put line guide ring back on, slot to outer edge. Remove the empty spool. Don't take spool apart unless you need to get inside to remove string. The outer half should be yellow. Cut 25 ft. of .065 line. Start pushing the line inside the spool from the center making sure the string is winding inside in a counter clock direction which should be shown on the spool. Keep pushing until there is about only 6 in. left. Replace spool. Then the line guide ring, making sure to pull the string through the middle of it. Then hold the string on the slot in the ring while replacing the cap. You should be set to go.
How do you remove the spool housing for a Black and Decker grass hog xp model gh 1000 type 4 to attach a grass gator grass blade head?
1. Remove the spool cover. 2. Remove the spool. 3. Use flathead screwdriver to remove the single screw in the center of the housing. 4. Pull. The housing straight off. (Note: it may be somewhat difficult to pull the housing off, but a strong firm pull should remove the housing. No turning is necessary.) 5. Put the new housing on, lining up the center hole on the housing with the center rod on the base. 6. Use flathead screw to replace the single screw into the center of the housing.
Need a spool cap for a task force battery operator weed whacker model 21023?
yes
What is a spool pin?
Spool pins are used on sewing machines to hold the spool of thread. Most or vertical, some that are horizontal use a spool cap to secure the spool of thread. Some machine come with spool nets to cover the spool to ensure the thread enter the machine evenly. Some machines come with an extra spool pin that fits into a small hole on the top of the machine to hold a second spool of thread.
How do you remove line spool from weedeater model rt 110?
Line up arrows and hash marks, then pull. It is held in place by a spring lock and should pull off with a little effort.
How much is a spool of tread?
A spool of thread is very cheap. Spools of thread can be as cheap as a dollar or less a spool.
How can you replace the trimmer line mac 2816?
Locate the trimmer head at the shaft. Remove debris in the head. Cut a 14-inch piece of the trimmer line and fold it. Place the spool against the spindle. Feed the ends of the line through the eyelets. Push the spool down and pull the trimmer line tight with your hands. Tighten the spool.
What is the procedure for re stinging the spool on a Weed Eater Model RTE113C?
Line the mark up with the arrow and pull real hard.
Craftsman model 257.796050 need to know how torestring spool?
Read the owners manual in the link below. It will explain how to restring the trimmer.
