Want this question answered?
To install a 2000 Yamaha Waverunner XL 1200 starter, first remove the 2 bolts. Then the wires connected to the starter. Remove the starter and replace with new.
Heres a UTUBE on it http://www.youtube.com/watch?v=bQ7nyMRnBIM
Begin with disconnecting the negative battery terminal. Remove the two bolts that hold the starter in place and also unfasten and remove the starter motor cable. The starter is easily pulled out.
NO, the clutch for the starter is internal. The clutch is on the gear that engages the starter gear.You have to remove left side engine case and remove flywheel to access starter clutch assembly.
It's a real pain. I had to bend the head of a wrench to get at one of the 4 bolts holding it in. If you have the engine out, it's real easy. A lot of times the starter is the not the problem on these bikes. The starter bendix that is behind the clutch is the problem if you hear grinding when you try to use the starter.
.035
There are a few online resources that offer information about the Yamaha FJR 1300, including Motorcycle News, Gogo Cycles, Rider Magazine, Web Bike World, and The Old Bloke.
In general, remove negative cable from battery, remove electrical wires from starter, remove bolts holding starter in place, remove starter. Replace starter in reverse order.
On the engine, stamped somewhere on the cases
no, but you can get them aftermarket
Remove - battery cable Raise and support vehicle Remove wiring at top of starter Remove starter mounting bolts Remove starter
disconnect power from battery, remove wires connected to starter, remove bolts from starter (usually 2), remove starter.