Do yourself a favor. If you are planning to install an aftermarket radio, buy yourself a radio wiring hardness that will fit into the factory wiring hardness. It will cost under $20.00. And it will save you lost of headaches in the future. No short, or problems... Remove Stock Ford Radio To remove the radio you will need a "Radio Removal Tool". This is a "U" shaped pin with a dent at the end. This can be commonly found at auto parts stores or, Walmart, etc (widely available for $3-$4). The radio has two holes in each end (four holes total) · Insert the removal tool into the holes on each side (This will release the catches holding the radio into the dash) · Slide the radio toward you The link below gives instructions for radio removal and includes photos http://www.installdr.com/InstallDocs/FLM/PDF/356007.pdf You can also make your own removing tool from a wire coat hanger: cut 2 U-shaped pieces (about 8" each) and insert them into the 2 holes in the front of your head unit; using a sideways motion and pulling towards you will do the trick, just be carefull when inserting the tool to not scratch the finish on the unit. I tried the wire hangar solution but went and bought the tool anyway. Either would probably work, but the tool is a bit more sturdy / stiff. Here are the instructions that come with the tool: * Disconnect negative battery wire * Insert the removal tool into the holes on either side of the faceplate * Push the tools forward about 1 inch until the retaining clips are released * Grasp the tools tightly and pull apart slightly as you pull the unit from the dash
How to remove the factory radio and disconnect wirring harnes in a 2004 f150 ford truck
It pull's off and snaps back on.
the transmission that is in a 1996 f150 is a 4r70w if automatic
How to Remove or Install Car Window Crank Handles check related link below
To remove hubs on an automatic 1996 Ford F150, first remove the silver cap that has 3 Torx screw using a Torx screw driver. Secondly, there is a snap ring inside the next part where those Torx screws came out of; remove it using the correct hub socket. The hubs come right off after removing the ring.
No, 97-03 F150's have a 5x135 lug pattern.
from 89 through 1996 the rims have the same bolt circle and from 1997-2003 and 2004-2011. However, if the tires are larger than stock on the 4x4 you will probly have clearance issues on the 2x4.
take radio out and look to left of radio
Im not sure, but why the hell would you want to do this?
A good majority of the 1984 Ford F150 gear ratio had 3.00 gears for the stock. In addition, the spline should be a 31.
take rubber cover off.phillip screws.cover pulls up but not offone bolt and it comes rite off.drop tranny .
9004