Want this question answered?
Remove the rear wheel from the axle. Remove the brake pads and hardware. Remove the axle end cap. Remove the bearing. Reverse the process to install the new bearing.
Begin by removing the rear tire and wheel. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel bearing seal and the wheel bearing.
You only need to remove the left hub assembly. Loosen the axle nut while still on four wheels. Having said that, put rear on suitable stand forward of the rear axle bearing carrier. For ease remove both rear wheels. Remove drive chain. Remove left hub. Remove brake caliper and secure. Remove the rear sprocket with flange together. There are two nuts on the axle that holds this in place. The nuts are different. The outer nut is a lock nut. Remove the outer and remover the inner nut. You can now slide the axle shaft out of the bearing housing. Now remove the housing after loosening the retaining bolts. Take the housing to a bench and remove seals and bearing. Note that there is a long spacer separating the bearing which is in the middle. This how I did this on my 86. Regards
yes
Remove the tire and wheel. Remove the axle end. Remove the axle seal. Remove the wheel bearing. Reverse the process to install the new wheel bearing.
Remove the rear tire and wheel. Remove the axle end cap. Remove the rear wheel seal. Remove the rear wheel bearing. Reverse the process to install the new wheel bearing.
Remove the rear tire and wheel. Remove the axle end cap. Remove the wheel bearing seal. Remove the wheel bearing. Reverse the process to install the new wheel bearing.
That might be the rear axle, it that is what you want to remove then you will need to remove the rear axle cover drain the fluid and the locate the center pin bolt and remove that in order to remove the center pin to get at axle c-clips then remove the c-clip for the axle you want to remove then slipe the axle out being careful not to distrub the axle bearing
The rear wheel bearing, on a Nissan Maxima, can be removed by first removing the rear wheel. Next, remove the axle cover. Slide the wheel bearing off of the axle. Reverse the process to install the new wheel bearing.
You will need to remove the rear tire and wheel. Remove the axle end cap. Remove the wheel bearing nut. Remove the wheel bearing and the wheel seal. Reverse the process to install the new wheel bearing.
Remove the tire and wheel from your Chevy Cavalier. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel bearing seal and the wheel bearing.
pull drum off and get an axle puller. Although correct this answer assumes you mean the rear axle. If that is the case pull the drum off after removing the wheel and remove four bolts holding the axle bearing to the differential housing (on opposite side of brake backing plate) and then use a reversible hammer (axle puller) to pull the axle out from the differential axle housing.