Want this question answered?
2 torix screws in the handle wells, then pull, it is clipped into holes if you do this carefully the clips will not break
It is located in the rear tailgate. Remove the inner panel and the support bracket on the right hand side to see it.
Strip off all the inner trim of the tailgate. undo all wiring clips and remove as much of the wiring loom as possible. Then tape all plugs tightly to the wiring loom and pull the remaining loom bacwards through the tailgate at th point where it enters from the body of the car. Then unclip the air struts by removing the spring clips from the ball joint of the strut and pulling them off (tailgate has nothing holding it open now so use a broom or piece of wood to jam it open before doing so). remove the pins from the hinges or unbolt the hinge from the tailgate depending on how it is fitted. It helps if 2 people are doing the job.
I think you have to take off the inner door panel and remove from there...Rick D
The inside of the tailgate, that is the part that faces up when the tailgate is down will have a panel that is held on by screws, it will give you access to the inner workings. Usually it is a little 20 cent retainer that has broken and is available at any parts store.
Need to remove the tailgate inner trim panel on hatch and estate car.The lamp is held on by two clips (estate)or two screws(hatch)the wiring needs a couple of ties undoing to remove the lamp.
You must remove driver side tire and inner fender(black plastic),It is up to your left
No, you remove the 4 nuts on the outside, and pull the axle shaft out with a slide hammer.
Mine was missing the knob for opening it, I bought a new one from www.rockauto.com and replaced it, there are two to chose from, I bought the cheap one and it was a complete unit with keys. You have to remove the inner panel from the tail gate to get access to the lock then remove the clip holding it in and replace it with the new one.
remove inner door panel for access to lock
you need a inner tie rod tool
its located on the front passenger side of the car.first take off the tire,then the inner fender and the crankshaft pulley will be right there. its also easier to do with air tools.