FIRST REMOVE THE TRIM PIECE THAT RUNS AROUND THE WHOLE DASH. IT POPS OUT, BUT BE GENTLE ENOUGH NOT TO BREAK IT BECAUSE IT IS PLASTIC. THEN ON THE LEFT AND RIGHT SIDE OF DELCO RADIOS THERE ARE TABS THAT YOU PUSH DOWN AND IT RELEASES THE RADIO. PULL THE RADIO STRAIGHT OUT. YOU WILL HAVE TO REMOVE THE ANTENNA PLUG FROM THE BACK OF THE RADIO AND THE WIRING HARNESSES FROM THE BACK OF THE RADIO. FOR A NORMAL DIN RADIO REPLACEMENT YOU WILL HAVE TO PURCHASE AN ADAPTOR KIT FOR THE OPENING. YOU CAN PURCHASE THESE AT ANY STEREO SHOP OR WAL-MART, OR RADIO SHACK. YOU WILL ALSO NEED TO PURCHASE THE ADAPTOR WIRING HARNESS TO FIT YOUR VEHICLE SO YOU DONT HAVE TO SPLICE ALL OF THE WIRING TOGETHER. MATCH THE WIRING FROM YOUR REPLACEMENT RADIO TO THE WIRING HARNESS AND MOUNT THE RADIO IN THE ADAPTOR KIT. INSTALL THE RADIO INTO THE OPENING AND PLUG ALL OF THE WIRING BACK TO THE FACTORY PLUGS. REPLACE THE TRIM RING BACK ONTO THE DASH AND YOUR DONE. ABOUT AN HOUR TO DO EVERYTHING IF YOU HAVE EVERYTHING READY TO GO. HOPE THIS HELPS!!!
you can't do it yourself you have to get help from a pro
Remove the 1993 Toyota decorative radio cover in. Remove the radio retaining screws. Pull the radio out. Remove the wiring harness.
Remove air filter assembly. Loosen Belt, place pan under steering box, disconnect high pressure and return hoses. Remove bracket to engine bolts, remove pivot bolt, remove bracket and pump as one whole unit. Then reverse the process to install.
If you are referring to the factory supplied radio, it is not a 'component' type radio. It must be removed from the dash and dis-assembled.
All the 99/04 WJ Jeep Grand Cherokees come with the cabin filter housing, but the filter was not a standard item. It had to be purchased as an after market accessory. You do not need to remove wiper arms to install the filter. Pull the rubber cowl weatherstripping outward. Remove the weatherstripping on the passenger side about halfway across toward the driver side. Remove the cowl grilled cover, it has plastic fasteners that does not need tools to remove. Start be pulling the end of the panel gently upward enough to pop the plastic fasteners up so you can remove them by hand. Be careful when pulling on the plastic fasteners as they could be very sharp on the edges. There will be an old plastic air inlet cover under that cowl grilled cover. You can either remove the plastic fasteners like above or you can cut the plastic rosebud fasteners. Clean the area and you are ready to install the new filter.
1.- remove the doors panels 2.- remove the old factory speakers
Yes
Remove the covers from your 2003 Chevrolet Avalanche speakers. Remove the speaker retaining screws. Remove the wiring harness from the back of the speakers. Reverse the process to install the new speakers.
Remove the tire and wheel from your Chevrolet Avalanche. Remove the brake spring and caliper. The brake shoes will come off. Reverse the process to install the new brake shoes.
Factory applied or after market? Factory applied would be great to know.
You will have to remove the factory oil sending unit and install it there.
you can't do it yourself you have to get help from a pro
On driver side, you will have to remove the steering assembly. With the passenger side you should only have to remove the factory manifold.
Yes
The water pump, on a Chevrolet Avalanche 5.3 liter, can be removed by first removing the water hose. Remove the four bolts to the water pump cover. The water pump will slide out. Reverse the process to install the new water pump.
go off roading
See page 3 or 4 of this list and you will find how to remove an old factory radio from a 95.