Want this question answered?
Passenger side, underneath the glove box. You have to remove a panel from the center console.
underneath the steering wheel there is a cover remove it and there is your fuse panel. it is a tight fit though
You must first remove the cover from behind the door open lever and the cover from the door handle....then remove the screws.... then remove the cover for the mirror that's on the inside its snaps off so a firm pull should do the trick, and then the same for the door it has like 20 or 25 snaps that all have to be undone... a quick pull will snap it out and then I'm sure you can figure the rest out :-)
Remove the screws in the door panel.
Pull
Open your hood and pull the body clips out of the front black panel. After doing so you should be able to remove it with a socket wrench and then just disconnect the wires.
== ==
Chevy Tahoe remove front and rear speaker
inside the transmission....you have to remove the side panel to get to it. It is a job for a dealer...cost will be about $800. The A-frame needs dropped along with the rack, and the tranny tilted back.
Using a screw driver, remove the screws and the clips in the panel of the door and remove the panel gently. Remove any wiring connectors between the panel and the door, then remove the panel the rest of the way.
Remove the instrument panel cover. Remove the instrument panel retaining screws. Remove the wiring harness from the gauges. The instrument panel will come out.
first you have to remove the part where the mirror is adjusted on the inside, it snaps off with 3 clips. You can stick a screwdriver under there wrapped in a little duct tape to keep it from scratching the door. After you do that, you have to remove the clips from the door handle in the middle and the door opening handle near the top, and remove the screws/bolts there. Make sure there are no bolts under that mirror cover that you just removed, then just start going around the door, its got the same clips as the mirror cover does, it will require some effort, and 1 or 2 can bend...chalk it up to chevy.....