This is right down the same line as "where the horn is"! At any rate, just go on over to Smokinvette.com and talk to some of the members there and they can answer any question that you can possibly come up with! Good luck!
A person can remove the front license plate cover on a 1990 Corvette with a screwdriver. The plate can then be replaced with a custom plate or a state plate if required.
There are screws holding it on. Un-screw them.
Are there people that use the front license plate still? lol Well taking them off if you are using them is quite easy, get a screwdriver and take the bolts out. Now if you have a custom plate holder you can get a detailed answer by visiting smokinvette.com. Good luck!
Lay down on the ground in front of the cover,look between the cover and the bumper and you'll see two Phillips head screws.remove them and your cover will be off.I just did this.
FYI I have an 84 vette and the front end is now worth a fortune as I never popped out the front plate section and left it original - there are under 300 left with original front end. Food for thought if you plan to keep the car long term.
In Virginia you do have a front license plate, but in Florida they do not.
It will be necessary to remove the front license plate and bracket. Remove license plate from bracket. Using a 3/16" drill bit, drill out the two pop rivets that hold the bracket to the bumper. This is from a a bull bar installation guide for a 2008 Ford Escape/2008 Mercury Mariner.
Open trunk, plate fits through a slot--just push up from the outside front of plate
how incomptent are you not to see the 2 screws holding the plate on????????????????
Yes, Idaho requires front license plate.
Hit a Large tree or pole
== == == == you don't it's molded int to the bumper.