FIRST, disconnect your battery. Then remove the glove box (4 small bolts/screws, two on each side). The ECM will be behind the glove box on the right side (it's the shiny metal box approximately 6"Long x 4"Wide x 1.5" Thick). Slide/pull it carefully to the left (towards you). You may have to pull open the two clips on the left side of it a little to get it loose (very easy to do by hand with you fingers). When you have moved it to the left and have enough room, disconnect the two wire connectors right in front of it. Move the connectors out of the way and pull the ECM out. Very simple job. To remove the chips from inside the ECM all you have to do is remove the two small screws that are holding a small plate on top of it. They are directly under that plate. I used a flathead screwdriver to CAREFULLYpry on each side of the chips evenly to pull them out. Again, very simple.
YES, All the cabs are the same from 1988 to 1999
how do you remove the heater core and hoses from 1996 Chevy sub 5.7 K1500
Drain the oil from your 1995 Chevrolet oil pan. Remove the oil pan retaining bolts. The oil pan will come off.
How is the easiest way to change a fuel pump on my k1500 Chevy pickup
16 inch rims
YES.
YES, Just the front doors will fit.
Remove the water return line from your 1998 Chevrolet pickup truck water pump. Remove the water pump belt. Remove the water pump retaining bolts. Reverse the process to install the new water pump.
1350-1450 @800rpms
my 1997 Chevy k1500 well run fine and then it trips fuel pump relay
Chevy says about 210hp.
Curb Weight: 4127 lbs std cab 5.0 engine