0
The bench of the back seat, actually pops out. You can grab the front of the seat and pull up.
For the back of the seat, you will have to remove two nuts holding the seat belts and two bolts holding the lower seat back. These will be visible once the bench is taken out. After removing the two bolts and two nuts, pull the lower part of the seat back (toward the front of the car) just far enough to clear the seat belt retaining studs. Then lift the seat back up (about two inches) to unhook it from the car. There are 3 hooks that the upper part of the seat back hangs on when it is installed. It may take some effort to do this and expect one side to pop before the other and then re-catch while you are trying to lift the other side. (It helps to have two people when doing this.) Be careful not to pull lower part of the seat forward too far or the seat back hooks will bend.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Is there a plate on 2004 Dodge Intrepid to remove a fuel pump on the back seat?
No, the tank has to be removed.
Can a Dodge Stratus motor and transmission fit in a Dodge Intrepid?
No, a Stratus engine sits transverse, while the Intrepid sits front to back.
How do you change your evaporator in a 98 Dodge Intrepid?
Remove the complete dashboard. This is NOT an easy thing to do! It is back there in the center behind the radio and passenger airbag.
How do you change the fuel filter on a 1995 dodge intrepid?
The fuel filter 1995 dodge Intrepid is on the passenger side. The filter is towards the back of the car.
Where is the O2 sensor on a 1994 Dodge Intrepid?
The 1994 Dodge Intrepid O2 sensor is located on the outside of the air cleaner housing. The sensor is on the back side of the housing.
Is there a reset button in 98 Dodge Intrepid to get the computer system back on after a rear end collision?
A Dodge Intrepid does not have a reset switch. The fuel system is computer controlled.
How do you replace oxygen sensor in 2004 Intrepid 2.7 liter engine?
The 2004 Dodge Intrepid oxygen sensor can be found on the back of the air cleaner housing. Remove the wiring harness. Remove the oxygen sensor retaining screws. Reverse the process to install the new oxygen sensor.
Where is the bank 02 sensor located po160 on 2001 dodge intrepid?
back 2
How do you remove the radio from a 1999 Dodge Intrepid?
First you must remove the dash plate that is held on by clips. So you must pull on it to get it off. Then there is four screws in the front and a ground bolt in the back. And you must remove the wire harneses and antena cable.
How do you diable the alarm system to a 1998 Dodge Intrepid?
You can not disable the factory alarm. It is built in as part of the computers. If it is a aftermarket alarm you should be able to remove it and put the car back stock.
How do you remove a factory stereo on a 2002 Durango?
Remove the 2002 Dodge Durango factory stereo decorative cover. Remove the factory stereo retaining screws. Pull the factory stereo out. Remove the wiring harness and the antenna cable from the back of the stereo.
What size bolts hold on the blower motor in a 2002 Dodge Intrepid?
8 mil and for the back one you will need a swivel make sure to pull away the carpet to make it much much easier
