To remove the back seat from most GM vehicles, Lift the front of the seat section then pull the seat forward. After the seat bottom is removed, there should be a couple bolts holding the bottom of the seat back into place. After removing those bolts you should be able to lift the seat straight up and remove it.
Remove the wiring harness from the back of your 1991 Chevy Corsica turn signal. Remove the turn signal retaining bolts. The entire turn signal will come out. Reverse the process to install the new turn signal.
Begin by removing the alternator belt on your 1989 Chevy Corsica. Remove the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install the new alternator.
Remove the wiring harness from the back of your 1996 Chevy Corsica blower motor. Remove the blower motor retaining bolts. Remove the fan from the front of the blower motor. Reverse the process to install the new blower motor.
its behind the coil packs on the back of block
how to remove back brakes on a 2002 Chevy surban
Push back on the bottom of the bench seat (takes a lot of pressure) to release holding clips Lift bench out Back of seat is secured by clips or bolts that are now accessible - remove these and lift upward on back of seat to release upper clips Remove seat back
On the back of the trans. There should be a vacuum line running to it.
On that year, You can just REMOVE the battery cable for about 10 mins. Then hook it back up.
remove platic trim panel that goes aroung radio and heater controls the remove to bolts located on bottom side of radio 10mm i think pull radio out disconnect wiring harness and ant from back
The 1990 Chevrolet Corsica TCC transmission solenoid is located on the top of the transmission. The solenoid will be near the back of the transmission.
if you have a 3.1v6 it is between the firewall and the valve cover on the back side of the engine.
If this car was special ordered with ABS it included fron and rear control.
You can remove the panel inside the back of the car. From there you can access your tail lights and your tag lights.
The headlight switch should be easily removed from the dash. There are two connectors on the back side of the switch (one for the headlights and one for the dimmer). Simply unpug the connectors and plug in the new switch.
It will be on the back side of the engine where the distributor used to be on older engines.
there are 3 in the front and 3 in the back of the motor near the fire wall
Hard to do , didn't Corsicas only start in 88??
Remove the cover from your 2001 Chevy Silverado stereo. Remove the stereo retaining bolts. Remove the wiring harness and the antenna cable from the back of the stereo.
The high beam switch is on the blinker. You either flick it back towards you or push it away from you.
Pop the trunk, pull back the trunk liner, remove the 5 plastic screws/wingnuts, and separate light assembly from the car, remove the bulbs and replace.
Should be by the alternator in the back
Remove the rear speaker covers in your 1994 Chevy Cavalier. Remove the rear speaker retaining screws. Remove the wiring harness from the back of the rear speakers.
i do not know...
cut it out