Hi, The battery is behind the driver side seat in the campartment. There should be a bolt that holds it down. If you look beside the battery towards the back you should see a half inch bolt, just take the bolt out and undo the battery cables from the battery. Lay a rag on the carpet so you dont get dirt and battery acid on it. RJ Sottile www.hobbycarcorvettes.net
behind the drivers seat
The 1976 Chevrolet Corvette has a 12 volt system.
To replace the battery on a 1979 Corvette, disconnect the battery cables using the proper tool. Remove the bar that holds the battery in place and pull out the battery. Place the new battery in and reconnect the cables.
Remove the lower panel from left fender .
maybe you can unbolt the universal joint and then slide it out of the spline
Will a 1976 Corvette C3 Hood fit on a 1978 Corvette C3.
Start by removing the ground cable first(negative). Then remove the positive cable. At the base of the battery is a hold down clamp, held in by one bolt. Remove this and the battery will lift right out.
Open hatch behind drivers seat......remove battery cables.....remove battery hold down clamp at lower back flange of battery...pull out battery....replace in reverse order.
You need to remove the small vented side panel. or at least remove the 3 screws from the wheel well and the one on the top of the panel. Then pull the panel out enought to remove the battery
Remove the positive cable from your 1975 Chevrolet Corvette battery. Remove the two cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
Remove the positive cable from your 1995 Chevy Corvette battery. Remove the cables from the front of your old starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
just like any other battery nothing special disconnect the terminals, remove the battery and put new one in