You need to remove the small vented side panel. or at least remove the 3 screws from the wheel well and the one on the top of the panel. Then pull the panel out enought to remove the battery
== ==
To get a 1990 Corvette to start if it turns over and the battery is good, check to ensure the fuel filter is not clogged. You also need to ensure it has plenty of gasoline.
To replace the battery on a 1979 Corvette, disconnect the battery cables using the proper tool. Remove the bar that holds the battery in place and pull out the battery. Place the new battery in and reconnect the cables.
Remove the lower panel from left fender .
A person can remove the front license plate cover on a 1990 Corvette with a screwdriver. The plate can then be replaced with a custom plate or a state plate if required.
The 1990 Chevy Corvette front drivers side speaker cover will need to be removed. Remove the speaker retaining screws. Remove the wiring harness from the back of the speaker.
Start by removing the ground cable first(negative). Then remove the positive cable. At the base of the battery is a hold down clamp, held in by one bolt. Remove this and the battery will lift right out.
Open hatch behind drivers seat......remove battery cables.....remove battery hold down clamp at lower back flange of battery...pull out battery....replace in reverse order.
Remove the positive cable from your 1975 Chevrolet Corvette battery. Remove the two cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
Remove the positive cable from your 1995 Chevy Corvette battery. Remove the cables from the front of your old starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
just like any other battery nothing special disconnect the terminals, remove the battery and put new one in
check the battery and connections/cables