Just did one last week. Disconnect the battery connections. You must then remove the large black brace you see going across the battery. You also must remove the air flow tube right behind the battery. Once you remove them, release the battery hold down screw, (bottom of battery) and work the battery out. It will come out by twisting it to the left. It is a very tight fit. Reverse the procedure to install the new one.
I am trying to drain old antifreeze and replace with new and cannot figure out how to remove the radiator plug on my 2001 Chevy impala 3400V6 engine?
You_want_to_put_a_sony_CD_player_in_your_2000_chevy_impala_and_take_out_the_stock_AM_FM_radio_can_you_do_that
Remove the tire and wheel from your 2001 Chevy Impala. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel bearing seal and the wheel bearing. Reverse the process to install the new front wheel bearing.
Where is the mounting bolt on a 2001 Chevy impala so I can replace the bletAnswerWhere is the mounting bolt on a 2001 Chevy impala so I can replace the blet AnswerWhere is the mounting bolt on a 2001 Chevy impala so I can replace the blet
if its a new battery then you need to replace your alternator. It basically recharges your battery while the vehicle is running.
Where is the EGR unit located on a 2001 Chevy Impala? picture please
Disconnect the Battery Negative (black) Cable & secure away from post. Jack up car & remove under cover. Disconnect the large & the small cables from the Starter. Remove the Starter mounting bolts. Remove Starter. Installation is reverse.....
All 2001 Chevy Impala's have a V6. Either the 3.4 or the 3.8. They all have 6 spark plugs.All 2001 Chevy Impala's have a V6. Either the 3.4 or the 3.8. They all have 6 spark plugs.
Just did one last week. Disconnect the battery connections. You must then remove the large black brace you see going across the battery. You also must remove the air flow tube right behind the battery. Once you remove them, release the battery hold down screw, (bottom of battery) and work the battery out. It will come out by twisting it to the left. It is a very tight fit. Reverse the procedure to install the new one.
Hi i have an 2001 Chevy impala and my service traction Light is on. plus my safety brake is locked
the cover comes off and you take the 4 screws out then unhook the cables
Remove Battery Negative Cable & secure away from post. Release tension on Belt Tensioner & remove Serpentine Belt from Alternator Pulley. Remove Battery Cable & Electrical Plug from Alternator. If applicable, remove Power Steering Line Clip from Alternator. Remove Alternator Mounting Bolts. Remove Alternator. Installation is reverse.....