There are six bolts that have a Torx head (T-50 size) on the floor of the bed. These come out, and the gas cap has to be removed (3 screws around the cap), and the wiring harness that runs along the back edge of the bed has to be disconnected (plug in the middle, just above where the hitch would be). Lift it straight up (overhead cables, ropes, 4 friends, whatever). Watch out for the mud flaps, and the diagonal braces holding the body.
There is 6 or 8 bolts on the bottom side of the bed take those off and remove gas neck and it should come right off.
Mazda made a b2200 and b2600 truck in 1989.As for performance the engine is rated at 85hp or so and really just a mpg truck not a power house for dragging trailers or too much weight.The truck is great for general use,and driving and hauling resonable things in the bed with ease over all.
Yes, you sure can. Decide which is easier, removing the bed or the fuel tank.
it is in the tank on drivers side. if you remove the bed bolts and shift the bed back you can access it quite easily. have done this on my own vehicle
As of 2014, there are a few places where you can find a bed cap for a 1986 Mazda B2000. This part can be found at local body shops and auto part stores and through Mazda.
in the fuel tank you can either remove the tank or the bed to gain access.
How to remove bed rails from a dodge truck
lower tank or remove bed of truck, if tank is full you cannot empty with syphon as check ball will not allow it, it is easier to remove bed to gain access and if you have stands you just have to raise it a little.
first line up about 4 or 5 of your best friends, then remove the 6 to 8 bolts, depending on the bed size, from the undernieth side of the bed,accessed through holes in the frame on a few of the bolts. next remove the fuel filler neck from the box side, then unplug the taillights from the frame wiring block on the rear of the truck, next get those friends to help lift the bed up and off of the frame
to remove a bed on a Chevy truck you have to 1 take the gas filler neck looose (three bolts) 2 un hook the taillight wires 3 ther are 8 bolts in the frame rail that hold the bed on the should be 18mm take them out and lift it off
you and me in bed
The cast of Breakfast in Bed - 2000 includes: John Does as John Does