This question answer requires a service manual Crank shaft pulley removal is a complicated procedure and should only be done by people with experience as many parts need to be removed including the timing belt which if not done properly will cause damage to the engine. It would take the novice at least a day to do the job and requires some specialty tools. Go to Team3s web site for all of the information needed or Erik Gross s site. You may as well do the 60k and change all of the other parts involved while you are at it. The motor is an interference motor and putting the timing belt on improperly will cause the pistons to hit the valves so "Beware"
To remove a crank shaft pulley you need to first jack up the car. Next, remove the bold holding the crack shaft pulley in place and remove the unit. Reverse direction to put the new crank shaft pulley on your car.
12mm /19mm
how to get the crank shaft pulley off of a 03 Hyundai elanta GLS
To the right of the crank shaft pulley. You should see a single black wire going up from the pulley. All you need is a 10MM socket to remove it.
A video instruction guide on how to check a crank shaft pulley can be seen on YouTube. Just type in "How to check crank shaft pulley", click on Search, then play the first video.
disconnect the battery, remove the bolt in the center of the pulley, then use a harmonic balancer tool to remove it
You have to get a pulley puller of the appropriate size. Without a pulley you have no chance safely to remove it. Be careful do not deform the pulley it's not that hard as you can think.
Check the crank shaft pulley
Im not sure which direction the bolt turns to remove the pulley...the crank shaft turns in clock wise direction when engine is running.
its loose tighten the pulley
It is on the front of the crank shaft and under the timing belt cover. You have to remove the crank pulley and all the belts and then the lower timing cover. It is not a job for a beginner.from : http://repairpal.com/crankshaft-sensor-569
Honda Crank Pulley Tool 50mm. The part number is 646796 at DenLorsTools.com. There is a video that shows it in use.