under the car with extention and universal, with a 11 mm.
The crank sensor should be on the drivers side of the transmission bell housing. It's more towards the top of the bell housing. The easiest way to get to it is reaching down from the top of the engine just below the valve cover. Atleast that is where it is on my 91 4.0L
paste this into your browser...i could not get the link box to take.. but this should ansewr the question on the o2 sensor
Top driver side of the bell housing.
yeah it has one and hope you don't have to replace it
When facing the engine it's located on the top right hand side of the bell housing, it's very hard to change.
how to remove crankshaft position sensor from 91 Buick Regal
The crankshaft position sensor is on the top driver side of the transmission bell housing.
You can not. The crankshaft position sensor is required to run the engine.
Yes.
it is what keeps ur cranks shaft timed and in the right position
The crankshaft position sensor is on the top driver side of the transmission bell housing.
The crankshaft position sensor is bolted to the bell housing of a 96 Grand Cherokee. It is at the top of the bell housing, just on the drivers side on a 4.0 L and on the passenger side on a V8.
The camshaft position sensor is inside the distributor. The crankshaft position sensor is in the top of the bell housing on the driver side.
CRANKSHAFT POSITION SENSOR The crankshaft sensor is located on the passengers side of the transmission housing, above the differential housing Crankshaft Position Sensor The bottom of the sensor sits above the drive plate REMOVAL Disconnect electrical connector from crankshaft position sensor. Remove sensor mounting screw. Remove sensor. INSTALLATION Install sensor and push sensor down until contact is made with the transmission case. While holding the sensor in this position, install and tighten the retaining bolt to 12 N·m (105 in. lbs.) torque. Connect electrical connector to crankshaft position sensor.
Crankshaft position sensor mounting bolt.
The crankshaft position sensor is on the top of the transmission bell housing behind the passenger side cylinder head.
Remove the engine brush cover under the front of the engine. Remove the drive belt to make changing the sensor easier (optional). Remove the lower timing belt cover and the crankshaft pulley to access the crankshaft position sensor. Disconnect the electrical modules from the crankshaft position sensor, located next to the alternator. Take off the bolts with a socket wrench and remove the sensor.