Its refered to as a harmonic balancer, and you have to have a special tool to remove it called (surprisingly) a harmonic balancer removal tool. The installation tool is a good heavy hammer and a block of wood. If you dont have access to this special puller, you can (and likely will) damage the harmonic balancer, so it would be best in that instance to take it to your local mechanic and ask him to take pull it off for you.
u need to buy new pulley then, remove serpentine belt from engine remove bolts that hold pulley to crankshaft remove pully instalation is exact opposite of removalAnsweru need to buy new pulley then, remove serpentine belt from engine remove bolts that hold pulley to crankshaft remove pully instalation is exact opposite of removal Answeru need to buy new pulley then, remove serpentine belt from engine remove bolts that hold pulley to crankshaft remove pully instalation is exact opposite of removal
Depending on engine displacement in general remove belt-s then bolt holding pulley to the crankshaft then using a puller remove the pulley, when installing use a installer not a hammer to put the pulley on the crankshaft.
The dual Crankshaft Position (CKP) sensor is mounted to the front of the engine, attached to an aluminum bracket mounted to the left side of the engine at the timing chain cover. A 4-wire connector plugs into the sensor, connecting it to the ignition control module.AnswerThe crankshaft senser is located under the dampener pulley. Remove the serpentine belt. Remove right front wheel. Remove plastic access cover that's behind that wheel. With an impact wrench remove dampener pulley bolt. With an Dampener pulley puller remove pulley. There is a plastic cover that snaps in place over the senser, remove it, and you will have access to the senser.Eric
on the Chrysler engine (420a) you do need a puller and installer to deal with the crankshaft dampener pulley.
In most cases you need a pulley puller. Need to know make, model , year and engine to help you more.
It should be behind the crankshaft pulley. You'll need to remove the right front wheel and the weathershields to get to it. If you only need to test the wiring, don't remove the pulley. == == == ==
Im not sure which direction the bolt turns to remove the pulley...the crank shaft turns in clock wise direction when engine is running.
What tools do you need to remove the crankshaft pulley on a 1995 Honda Passport?
The crankshaft pulley unbolts from the harmonic balancer. The harmonic balancer can be removed from the crankshaft with a 3 bolt puller.
Pulley is pressed onto pump, you need a puller to remove.
Hello! The crankshaft position sensor is located behind the crankshaft pulley,on the left side facing the front of the car.It is difficult to see and to remove it you need to remove the crankshaft pulley ( radiator,belts,.... )
Remove crankshaft pulley& ballance