Ford Taurus
Ford Focus
Ford Ranger XLT

How do you remove the dome light cover of a 2001 Ford Focus to check or replace the bulb?

161718

Top Answer
User Avatar
Wiki User
Answered
2007-03-19 00:32:03
2007-03-19 00:32:03

It just pulls down. There is a tap I just pull on it with my finger. You can use a regular screwdriver to assist. One side has the pull down tab and the other side slips out once it is off.

001
๐Ÿ˜‚
0
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Related Questions


If you're talking about a Focus, there is a panel in the trunk area.


How do you remove the brake light cover on a ford focus




How do you remove cover to replace brake light on 57 kia Rio


How to remove battery cover to replace battery


remove the derby ( round ) cover from the primary. fill til it tries to run out. replace derby cover.


remove the headlights by the 2 torx heard screws and pull them out, then reach down in behind the bumper cover


To replace the bulb for the interior light of a car, one should remove the lens cover, remove the burnt out bulb, inspect the socket for dirt or corrosion, inspect the lens cover for damage, check for loose wires then install the new bulb and replace the cover.


ondo valve cover, bolts remove valve cover, remove old gasket from valve cover and block. clean both surfaces well. put gasket glue on one side of gasket and install on cylinder head. align valve cover than replace bolts . tighten in a cross pattern until thet are snug. don't overtighten.


There are no headlamp washers on the American Focus ST's.


For a 2002 MDX, there are four screws to remove the cover. Then remove the spring ring holding the intake hose. Remove the cover and replace the air filter. Replace the cover and screws and then reconnect the intake hose and spring ring.


To replace a headlight bulb, you will first need to remove the cover and existing bulb. Check your owners manual for instructions on how to do this.


Truck headlights can be found at your local auto supply store. Unscrew the cover for the old headlight, remove it and then remove the old headlight. You will need a screwdriver and possibly a wrench for this. Next, replace the broken headlight with the new one, and replace the headlight cover. Lastly, check to make sure the new headlight works.


Remove cam gear, remove broken back cover, replace back cover, replace timing belt.


To replace the dashboard lights on the 1997 F-150, you will first need to remove the dash bezel and dash cover in order to access the lights. Then, remove the instrument panel cover below the bezel and remove the burned out lights. Replace the lights and add the cover, dash cover, and bezel back to the dashboard.


remove motor mount "dog bones" and also label/remove spark plug wires from spark plugs, remove valve cover, clean cover from debris, use light coat of oil to stick gasket, replace round rubber gaskets, replace cover, wires and "dog bones"


hello i need you help me tell me how to remove the cover light from a license plate i have a ford focus se 2002 to put a new light thanks willie


open the trunk, remove the plastic cover assy, remove the required bulb, 1/2 turn and replace same. Replace plastic cover, by pushing the plastic rivits stright in.


Disconnect the battery, remove the cover, remove the cables and boots, and remove the spark plugs. Put in the new spark plugs, replace the cables and boots, replace the cover and connect the battery.


First you remove the plastic engine cover on top of the valve cover. Then you remove the wires from each of the three coils, then you remove the bolt holding each coil and remove coil. Down in that hole is the spark plug, remove with socket and replace.


Ensure the device is switched off. Then, remove the battery cover. Remove the old battery from the device and replace it with a new one. Replace the cover and power back up to ensure the new battery is working.


The first thing to do is to open the cover of the battery compartment. Remove the old battery. Replace this with a new battery. Replace the cover and check that the watch is still working. If the watch is still within its warranty period, then DKNY will replace the battery for you, however, it will need to be mailed to the service center.


You don't, you change the bulb from inside the luggage area. To replace a broken red plastic tail light cover on a 2003 Ford Focus SE, open the trunk of the car. Look in the area inside the trunk opposite of where the tail light is located on the outside of the car. There will be 3 thumbscrews and one Phillips head screw used to attached the tail light cover. Remove all the screws. Pull the broken light cover away from the body of the car. Replace with new tail light cover and replace and tighten screws.


Disconnect the battery, remove the cover, remove the spark plug cables and boots, then remove the old spark plugs. Put in the new spark plugs, replace the cables and boots, replace the cover and connect the battery.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.