Want this question answered?
It will not take long at all to remove door trim from a Renault Menage. All you have to do is remove the bottom 10 mm bolts on the door, un-clip the door lights, undo the plastic trimming from the clips, unscrew the door cover and then remove all trimming.
take screws out and pull door trim off
Take off door handle by using thin flat head screw driver to remove the C clip. Remove part of the door handle. Take off hand rest. Undo he two screws behind it. Then you need to use your fingers or a tool to prise pull door trim away from the door. There are about 8 plastic studlike things which connect it. Then grab bottom of door trim and pull it about 2 inches away from the door and push it up. The whole thing will come off.
By the door handle, there's that little plastic cap. Pop that off, T15 driver to remove the screw. Remove the bezel. In the 'door close pull', remove the false cover. 7mm screw. Go along the edge of the door trim. At the back and bottom (front doors only) are two more T15 screws. Remove them. Finally, use a trim puller to remove the door panel. Don't just pull, you'll break the door panel itself, and Ford charges a good $700 for new ones.
The inside door trim is held in place by several retaining clips. Pry outward on each retaining clip to remove the trim.
remove small round plastic cap behind inside door handle, remove the screw, remove screws from door panel edges, starting at the bottom..pull the panel straight off the door. a door trim tool (if available) may be used to release the clips behind the panel
remove the single crosshead screw in the air vent, pull the top sill of the door card back one clip, remove the tweeter and remove the trim over the top of the window - you should then have access to the three retaining bolts and the electrical connections
You have to take the inside door trim out of the door, then there will be some bolts on the inside of the door remove the nuts and your door latch will come out.
hard to do but simple, lift strait up and pull outwards away from door, there are a couple of wires atached
http://www.bodyshopzone.com/archives/trim/door_panels/Oldsmobile/Cutlass_93/remove_dp_Cutlass.html
remove the inner door panel, you can access the bolts from the inside of the door.
* Remove the door trim panel * On power mirrors unplug the electrical connector * Remove the triangular cover over the mirror mounting * Remove the bolts and detach the mirror from the door * Installation is the reverse of removal