After removing the retaining screws, trim panel screws and either the manual window crank or the door switch panel and control switch assembly, grasp the trim panel and lift up and pull out at the same time.The trim panel has retaining hooks that must be lifted up to remove. Good luck!
Go to this website. It will show how to remove the door panel.
Begin by removing the inside door panel on your 1997 Plymouth Grand Voyager. Remove the door lock linkage. Remove the door lock retaining bolts. The door lock will come out.
The bcm is located behind the fuse panel under the driver side below the steering wheel there is a plastic panel and when you remove that there is the fuse box and behind the fuse box is the bcm
It is on the back side of the under dash fuse panel on the driver side of the dash.
Under the hood, along the driver side inner fender panel.
on the left side of the driver and under the dash. right by the door there is a panel that you open.
There are two. One is under the hood, next to the battery. The other is under the dash on the driver side.
http://neons.org/howtos/door/
The horns are located in front of the wheel on the driver side of the vehicle. There is a round panel which can be turn and removed to get to the horns and connectors.
There is a small plug on the inside panel, remove it and there is a release lever inside the door.
Ours is next to the fuse box, underneath the paneling. You have to unscrew and remove the whole panel to even see it.
The fuse will be either located in the fuse box in the car (usually in the driver side left panel, or under the hood), or it is located on the back of the radio itself.