Want this question answered?
If code isn't written in the owners manual then remove the drivers door panel and get the code on label of the door handle.
To open the fuse panel, you will need to fit yourself between the dash and the drivers seat. Once there, you should be able to see the clips that are holding the cover on the fuse panel to allow you to remove it for access.
How do you remove the drivers door panel and fix the window. It fell off the track.
On a 2004 Ford Freestar : The transaxle ( transmission ) is located in the engine compartment on the drivers side . It is bolted to the " rear " of the engine
drivers side front, remove the wheel, and you'll see a sensor with a retaining bolt in the transmission housing.
NO, you need to remove wiper arms and remove about a dozen screws that take off the panel in front of the windshield, with panel off there 4 bolts that you remove under the panel and you have open room to get to the back plugs. It takes around 2 hours,
On a 2004 Ford Freestar : The fuel pump inertia switch is located in the cargo area behind the service panel cover on the passenger side of the vehicle
I have a drivers side (front) speaker that went out. I think the problem is a speaker connection. How do I remove the window crank (not power windows) and then the whole inside panel?
On a ( 2004 ) Ford Freestar : The passenger compartment fuse panel is below and to the left of the steering wheel , by the brake pedal ( it has a cover on it )
You can view the 2004 Ford Freestar owners manual online at : www . motorcraft service . com ( no spaces ) Click on Owner Guides ( the fuses and relays section starts on page 195 , it has diagrams and lists for the fuse panel , which has a cover on it , and is located below and to the left of the steering wheel , by the brake pedal, and the power distribution box located in the engine compartment , on the drivers side , near the engine air filter and battery )
Below and to the left of the steering wheel , by the brake pedal
Door Panels Removal & Installation 1. Remove the sail panel (Front Doors Only). 2. Remove the door panel by carefully lifting the panel upward to release the retaining clips. 3. Remove the electrical plugs that control the windows, exc.The installation is the reverse of the removal.