answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered
2006-09-30 19:01:22
2006-09-30 19:01:22

It takes a special wrench (available @ most parts houses). The large hex, close to the pulley , must be un-screwed. The 4 small bolts only hold on the pulley. If I remember correctly, it is a left-hand thread.

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The oil pressure switch on a 1997 Chevy Tahoe is located on the back of the engine. It is in the center-rear part of the engine.


NO there is not. But boy that sounds good don't it. YOU MUST REMOVE THE FUEL TANK.


It is up inside the bottom of the engine, You will have to remove the oil pan from the bottom of the engine to service the oil pump. Pretty good job to tackle if your not a mechanic.


What is the operating temperature of the cooling system of a 1997 Ford 460 cu in engine.


cooling system capacity, 1997 gmc 5.7 liter engine


location of knock sensor in 1997 cheverolet Tahoe SUV 305 or 350 engine


Drain the water from your 1997 Chevy Monte Carlo cooling system. Remove the water supply hose. Remove the thermostat housing retaining bolts. The thermostat will lift out. Reverse the process to install the new thermostat.


What is the towing capacity of 1997 Tahoe?


where is my cooling fan relay controll circuit located in a 1997 Chevy lumina, 3.1 engine


It is on the right side (passenger) of the engine below the exhaust manifold.


It is screwed into the passenger side of the engine block just in front of the starter.


It is screewed into the passenger side of the engine block, Just in front of the starter.


NO. You need a VORTEC engine from the year 1997 to 1999


== == == == the 2007 probably has a different offset than the 1997. == ==


If you have replaced the relays in your 1997 Toyota RAV 4, the engine cooling fan may not come on when it is supposed to because of a failure in the wiring, the thermostat that sends to the fan, or the fuse for the cooling system.


no it does not, you will have to remove the fuel pump relay or fuse to shut it off.



On a 1997 Lincoln Continental : From a drawing I was looking at , the engine cooling thermostat is located in the AREA BELOW the engine oil filler cap when you are looking from the front of the vehicle into the engine compartment




You will have to remove what ever is covering it up. A/c compressor, Power steering pump. You have to be able to drive it side ways in the block with a hammer and chisel. Then pull it out and sand the side's of the hole in the engine block and clean it. then get a socket that will fit into the new plug and drive it back in until it is flush with the engine block. then put it all back together.


It is the only electrical part that's in the distributor. Remove the cap and rotor and you will see it.


The engine is removed out the bottom. You lower the engine and transmission out the bottom at the same time.


I own a 1997 Tahoe and I have a 2003 trans, no fit


No you do not, it is not in the way. First remove the transfur case from the back of the transmission. Then you will have enough room to remove the trans.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.