Fuel and Engines
Toyota Camry
VW Beetle Type 1

How do you remove the engine from a 1988 Toyota Camry?

Top Answer
User Avatar
Wiki User
Answered 2005-08-29 17:08:48

I have found the model specific manuals sold at Auto Zone to be reasonably priced and easy to follow. They have good step by step instructions for this. Be sure to take pictures or video so you can refer back to them when you cant remember where a wire or vacuum line goes. Manuals can provide on so much detail.

User Avatar

Your Answer


Still Have Questions?

Related Questions

How do you set timing marks on 1988 Toyota Camry engine type is 3S-FE 4-cylinders.?

1988 Toyota Camry, engine type is 3S-FE

How do you change a fuel injector on a 1988 Toyota Camry?

How do you change a fuel injector on a 1988 Toyota Camry

What is the spark plug gap on 1988 Toyota Camry?

what is spark plug gap for a 1988 Toyota Camry? using a 5503 autolite.

How do you replace the thermostat on a 1988 Toyota Camry?

thermostat is located on engine block. follow top water hose leading to engine. thermostat is located inside the water intake. remove hose. remove water intake(two bolts)housing. replace thermostat. .

What is the fuel tank size of a Camry 1988?

On a 1989 Toyota Camry, the fuel tank capacity is 15.9 gallons.

How to replace the front speakers on a 1988 Toyota Camry?

A very short Phillips head screwdriver to remove the 2 screws in the cover and lift out. There is not much roomk.

Will a 1988 Toyota Camry starter fit on a 1990 Toyota pick up 22r-e?


Where is the turn signal relay located and how do you replace it located on a 1988 Toyota Camry?

it is in taylorville

What is the tire size for a 1988 Toyota Camry 4 cylinder?


How do you replace the water pump on a 1988 Toyota Camry 4 cylinder?

In order to replace the water pump on a 1988 Toyota Camry v4, first remove the front timing belt cover as well as the motor mount on the passenger's side of the vehicle. In order to remove the mount, the engine must be supported. Before removing the timing belt, mark the camshaft and crankshaft for guidance during replacement. Remove the water pump, and apply new gaskets to the new water pump with a sealant. Install the new pump, then the hardware that had been removed in order to access the pump.

How many quarts are required to fill an 88 Toyota Camry transmission?

The 1988 Toyota Camry transmission has a fluid capacity of 6.3 quarts. You can check the transmission fluid level with the transmission fluid dipstick.

What is the specification of battery of 1988 Toyota Camry?

Most any 12 volt battery will work in your car.

How do you replace keys for 1988 Toyota Camry?

Call up a locksmith and have a talk with him will direct you in the right direction.

Can excessive free play in the rack and pinion of 1988 Toyota Camry be ajusted out and how When you remove the wheel there is about 5 mm through the tie rod into the rack and pinion?

Its not the rack its the tie rod ends.

What do you need to replace the rear bumper on 1988 Toyota Camry?

There should be 2 access plugs on each side in the trunk. Remove the bolts and slide the bumper out. Maybe a foot in from each side.

Where is the ECU on a 1988 Toyota Camry station wagon and how can you check it?

Behind the Glove box. Behind the glove box.

Why would a 1988 Toyota Camry not go in drive but in first and second okay?

The gear box has gone bad.

Does a 1988 Toyota cressida have a carburetor?

No, its fuel injected engine

How do i remove a Windshield washer pump on a Toyota 4-runner?

How do I remove a windshield washer pump from a toyota 4-runner 1988?

How do you remove a 1988 Toyota pickup shift knob?

You just unscrew it.

1988 Toyota Camry brake?

Yes, it came with 2 sets of brakes. One is for normal driving and the other is for emergencies.

How do you remove the stereo in a 1988 Toyota Corolla?

Remove the plastic panel, remove the bolts, disconnect the wires from the back of the stereo and remove

What engine is fit to Toyota 4runner 1988 model?

22RE or the 3.0L.

What car does the 1ggze supercharged engine come from?

toyota crown 1988

How do you replace the water bypass pipe on 1988 Toyota Camry?

I'm dealing with the same problem on my station wagon Camry 1989. Pep boys say have to order thru Dealer